Cecotec Bolero DressCode 10900 Inverter A Handleiding (400 Pagina's)

Handleiding

/ 400

Je bekijkt pagina 121 van 400

BOLERO DRESSCODE 10900 INVERTER FULLCOLOR A

BOLERO DRESSCODE 10900 INVERTER FULLCOLOR STEEL A

BOLERO DRESSCODE 10900 INVERTER FULLCOLOR ICE BLUE A

121

ENGLISH

- Remove any coins, buttons, and other objects from the seal after each wash.

Descaling of appliance

- As long as you use the correct amounts of detergent with the wash loads, descaling

is not necessary. If it is necessary to descale the drum of the appliance, follow the

instructions of the manufacturer of the descaling product.

- Small amounts of descaling agent can be used to remove white stains on the washing

machine drum caused by limescale or mineral deposits or small amounts of rust

caused by metal objects left in the drum.

NOTE: descaling agents contain acids which can attack parts of the appliance and

discolour the laundry.

Checking the water supply hose

Check the water supply hose at least once a year. If there are cracks, it should be replaced

immediately, during the washing cycle, the water pressure is very strong, and a cracked

water supply hose could easily open.

Cleaning the detergent dispenser tank

If there is a build-up of residual detergent or additives, or if the softener compartment

is not rinsed well enough, the drawer must be cleaned to avoid water overows due to

blockages. Fig. 18

1. Open the detergent drawer. Press down the tab (1) and pull the drawer (2) completely

out of the washing-machine housing.

2. Remove the liquid detergent cap (3) by holding it and pulling it upwards from the

detergent drawer.

3. Clean the lid and the drawer itself under running water. Lightly wipe o any remaining

detergent residue.

4. Replace the cap and reinsert the drawer back into place.

Tip: do not operate the appliance without the detergent drawer in place. If the appliance is

not in use, always keep the drawer closed.

Warning

Do not use alcohol, solvents, or chemical products.

You can use a soft brush to remove detergent residues adhering to the drawer.

Cleaning the mesh lter in the water supply hose and the water inlet valve

1. Close the tap (stopcock) and unscrew the water supply hose (Fig. 19).

2. Carefully clean the mesh lter at the end of the hose with a ne brush (Fig. 20).

/ 400

Bekijk gratis de handleiding van Cecotec Bolero DressCode 10900 Inverter A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.