Cecotec Bolero Aguazero 6700 B handleiding

Vaatwasser

Cecotec

119 pagina's

PDF beschikbaar

Handleiding

Bolero Aguazero 6700 B

Bolero Aguazero 6700 Inox B

Bolero Aguazero 6700 Dark B

Bolero Aguazero 6700 B

Bolero Aguazero 6700 Inox B

Bolero Aguazero 6700 Dark B

6362

ENGLISH ENGLISH

Warning:

- If the dishwasher is not correctly levelled, water leakage, problems with closing the door

or some noises may occur.

- If the recess of the cabinet in which the dishwasher is to be installed is narrower than

recommended, the dishwasher must be levelled and aligned correctly; otherwise, water

leakage will occur, you will not be able to close the door or the dishwasher.

- If you notice friction or any problems when opening the door, it means that the dishwasher

is not properly levelled.

Feet adjustment

- The feet should be adjusted as necessary until the dishwasher is completely stable.

- If you wish to raise the dishwasher, adjust the feet clockwise; if you wish to lower it, adjust

the feet counterclockwise.

- Use a at-blade screwdriver or a suitable tool to adjust the feet as shown in gure 5.

Case I: door tilts to the right

1. Unscrew the left rear foot by turning it counterclockwise and level it (Fig. 6).

2. Check that the door opens and closes normally. If not, repeat the previous operation.

Case II: door tilts to the left

1. Unscrew the right rear foot by turning it counterclockwise and level it (Fig. 7).

2. Check that the door opens and closes normally. If not, repeat the previous operation.

Free-standing installation (Fig. 8)

- If the dishwasher is placed in a corner, at least 50 mm must be left free between the

dishwasher and the adjacent wall to ensure that there is sucient space for the door to be

opened and closed without diculty.

- If necessary, it can also be reinforced using wooden slats (not included). Fig. 9

Warning:

- Place the dishwasher on a rm, at oor.

- Do not install the dishwasher on a raised surface.

Installation under a worktop (Fig. 10)

- Please note that you may need holes on both sides to allow the hoses and power cable to

pass through (approx. 100 mm x 75 mm).

- One of the holes should be as close as possible to the sink to facilitate the connection of

the water inlet and drain hose.

- To ensure trouble-free drainage, the distance between the dishwasher and the sink should

not exceed 1 m.

- Make the necessary height adjustments before installing the dishwasher.

packaging materials are recycled accordingly.

- Make sure all parts and components are included and in good conditions. If there is any

piece missing or in bad conditions, contact the ocial Cecotec Technical Support Service

immediately.

Box content

- Dishwasher

- Instruction manual

- Energy eciency certicate sticker

- Water supply hose

- Funnel for salt

3. INSTALLATION

- Place the cutlery basket in the bottom basket.

- For best performance, place the internal parts along the basket as shown in gure 3.

- Remove all packing materials from the inside and outside of the dishwasher before

installation.

- Keep this instruction manual in a safe place for future reference. If you sell, give away or

move the appliance, make sure to keep this manual with the appliance, so that the new

owner can refer to it at any time.

- Please read this instruction manual carefully: it contains important information on the

safe installation, use and maintenance of the appliance.

- If it is necessary to move the appliance at any time, keep it in an upright position; if

absolutely necessary, it can be tilted on its back.

- Figure 4 shows the overall dimensions of the appliance.

Positioning and levelling

- Remove the device from its packaging and check that it has not been damaged during

transport. If it is damaged, please contact the ocial Cecotec Technical Support Service

and do not continue with the installation process.

- Check the dishwasher and place it in a suitable location.

- Place the dishwasher on a level, stable and sturdy oor. If the oor is uneven, the feet of

the appliance can be adjusted until it reaches a horizontal position (the angle of inclination

should not exceed 2 degrees). If the appliance is correctly levelled, it will be more stable

and much less likely to move or cause vibration and noise during operation, as well as to

prevent possible water leaks.

Bekijk gratis de handleiding van Cecotec Bolero Aguazero 6700 B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.