Handleiding
Je bekijkt pagina 13 van 261
A(mm)
B(mm)
C(mm)
D
E
760
50 mini
20 mini
Air intake
Air exit 5mm
Before you install the hob, make sure that
• the work surface is square and level, and no structural members interfere with space
requirements.
• the work surface is made of a heat-resistant material.
• if the hob is installed above an oven, the oven has a built-in cooling fan.
• the installation will comply with all clearance requirements and applicable standards
and regulations.
• a suitable isolating switch providing full disconnection from the mains power
supply is incorporated in the permanent wiring, mounted and positioned to comply
with the local wiring rules and regulations.
• The isolating switch must be of an approved type and provide a 3mm air gap contact
separation in all poles (or in all active [phase] conductors if the local wiring rules
allow for this variation of the requirements).
• the isolating switch will be easily accessible to the customer with the hob installed
• you consult local building authorities and by-laws if in doubt regarding installation
• you use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
surfaces surrounding the hob.
When you have installed the hob, make sure that
• The power supply cable is not accessible through cupboard doors or drawers.
• There is adequate flow of air from outside the cabinetry to the base of the hob.
• If the hob is installed above a drawer or cupboard space, a thermal protection barrier
is installed below the base of the hob.
• The isolating switch is easily accessible by the customer.
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply
force onto the controls protruding from the hob.
Locating the fixing brackets
• The unit should be placed on a stable, smooth surface (use the packaging). Do not
apply force onto the controls protruding from the hob.
• Fix the hob on the work surface by screw four brackets on the bottom of hob (see
picture) after installation.
• Adjust the bracket position to suit for different work surface’s thickness.
Cautions
x The hob must be installed by qualified personnel or technicians. We have
professionals at your service. Please never conduct the operation by yourself.
x The hob shall not be mounted to cooling equipment, dishwashers and rotary dryers.
x The hob shall be installed such that better heat radiation can be ensured to enhance
its reliability.
x The wall and induced heating zone above the work surface shall withstand heat.
x To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
x A steam cleaner is not to be used.
x This ceramic can be connected only to a supply with system impedance no more
than 0.427 ohm. In case necessary, please consult your supply authority for system
impedance information.
Connecting the hob to the mains power supply
The power supply should be connected in compliance with the relevant standard, or a
single-pole circuit breaker. The method of connection is shown below.
12
Bekijk gratis de handleiding van Candy CI642CBB/1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Candy |
| Model | CI642CBB/1 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 54341 MB |
Caratteristiche Prodotto
| Apparaatplaatsing | Ingebouwd |
| Soort bediening | Touch |
| Kleur van het product | Zwart |
| Timer | Ja |
| Gewicht | 11000 g |
