Cambium Networks cnMatrix EX2010-P Handleiding (320 Pagina's)

Handleiding

/ 320

Je bekijkt pagina 172 van 320

L3 Features 172

How to Enable Routed Interfaces in CLI Interface (Example 1)

1. Type the config terminal command into the terminal.Press the Enterkey.

2. Type the interface gigabitethernet 0/1 command into theterminal to select an interface to be

configured. Press the Enterkey.

3. Type the shutdown command into the terminal to disable a physical interface. Press the Enterkey.

4. Type the no switchport command into the terminal to set the interfaceas aroutedport and to

erase all L2 interface configurations. Press the Enterkey.

5. Type the no shutdown command into the terminal to enable a physical interface. Press the

Enterkey.

6. Type the ip address 10.100.200.50 255.255.255.0 command into the terminal to set the IP address

of the configured interface. Press the Enterkey.

7. Type the end command into theterminal to go to the Privileged EXEC mode. Press the Enterkey.

8. Type the show ip interface into the terminal to display the IP interface status and configuration.

Press the Enterkey.

Note:

In case the command is used without the vid parameter the system allocates the greatest

VLAN ID available.

/ 320

Bekijk gratis de handleiding van Cambium Networks cnMatrix EX2010-P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.