Cambium Networks cnMatrix EX2010-P Handleiding (320 Pagina's)

Handleiding

/ 320

Je bekijkt pagina 129 van 320

L2 Features 129

Configuring Rate-Limit-Output in CLI Interface (Example)

1. Type the configure terminal command into the terminal. Press the Enter key.

2. Type the interface gigabitethernet 0/1 command into the terminal to select the interface to be

configured. Press the Enter key.

3. Type the rate-limit output rate-value 4096 burst-value 2 command into the terminal to configure

the rate-limiting and the burst packet rate for the interface. Press the Enter key.

4. Type the end command into the terminal to go to the Privileged EXEC mode. Press the Enter key.

5. Type the show interface rate-limit into the terminal to display the interface status and

configurations (verify if the rate-limit and burst size are displayed in the output with the previously

configured values). Press the Enter key.

Rate-Limit-Input

Managing Rate-Limit-Input (Example)

The Rate-Limit-Input feature limits the ingress traffic of the switch on a port by using ACL’s to capture

any traffic that ingresses that port and a meter to limit the traffic based on the configured rate in

kilobytes.

Standards

N/A

Scaling Numbers

N/A

Default Values

/ 320

Bekijk gratis de handleiding van Cambium Networks cnMatrix EX2010-P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.