Handleiding
Je bekijkt pagina 12 van 20
12
3. CONTROLS
The ERV100S unit is equipped with an integrated control. The electronic device is located under
the unit, in front of the electrical compartment. Refer to the figure at right for steps 3.1 up to 3.4.
Plug the unit.
The unit booting sequence is similar to a personnal computer boot sequence. Each time the unit is plugged after being unplugged,
or after a power failure, the unit will perform a booting sequence before starting to operate.
If a problem occurs during the unit operation, or if the unit turns in Protection Mode, its LED (1) will blink. The color and the blinking
pattern depend on the type of error detected, or if the unit is in Protection Mode.
Refer to the sticker on the unit and Section 9 Troubleshooting on page 22 for further details.
3.1 BooTing sequence
VC0152
1
2
During the booting sequence, the integrated control LED (1 in above illustration) will light up and remain GREEN or AMBER for
3 seconds, and will then shut off*; the booting sequence is done.
* or will light up in the color of the previous mode to show the unit resumed to it, if the unit is controlled by its integrated control.
NOTE: No command will be taken until the unit is fully booted.
3.2 inTegraTed conTrol
led Color results
AMBER uniT is on loW speed
GREEN uniT is on HigH speed
no ligHT uniT is oFF or conTrolled By a main conTrol
Use the push button (2) to control the unit. The LED (1) will then
shows on which mode the unit is in. Refer to table at right.
NOTE: When using main control, the integrated control
must be turned off.
3.3 seTTing exTended deFrosT
These units are factory set to normal defrost. In cold region (outdoor temperature -17°F
and lower), it may be necessary to setup extended defrost. During the first 3 seconds of
booting sequence, the integrated control LED shows the current defrost mode (refer to
table at right).
led Color defrost Mode
GREEN normal
AMBER exTended
Within the first 3 seconds of booting sequence, press on push button until the LED starts to blink, then release the push button; the
LED will blink AMBER 5 times. After that, the LED will shut off, then turn RED (the unit returns in its booting sequence).
Bekijk gratis de handleiding van Broan ERV100S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Broan |
| Model | ERV100S |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 3153 MB |
