Brandson 307510 handleiding
Handleiding
Je bekijkt pagina 21 van 56
21English
5. Assembly
Take the table fan out of the package and check the device as well as the scope
of delivery menoned in the table above. Please contact the vendor if any part is
missing or damaged.
At rst, remove the pre-assembled protecve cage locking screws (5) from the
motor unit (11). Now place the rear protecve cage (6) on the fan unit (8). Make
sure that the handle (7) is facing up. Tighten the protecve cage rmly using the
mounng nut (5). Then insert the rotor blade (3) on the motor sha (8) and x it
with the appropriate xing screw (4) sidewise of the rotor blade.
Cauon: Make sure that the notch of the motor sha (8) is in the correct posion.
Mount the front protecve cage (1) onto the rear protecve cage. A hole is provid-
ed for the locking screw at the boom of the two protecve cages.
Insert the locking screw through the hole of the front and rear guards and fasten it.
Then press the protecve cage - xing bracket (2) over both grids.
Now remove the xing screw (18) and the shim (17) from the stand pipe (19) of
the fan. Then you can place the basis (12) in the centre of the stand pipe (19) and
x it using the shim (17) and the xing screw (18). The table fan is ready for use.
12 Basis
13 Knurled screw (small)
14 Closing screw
15 Check screw
16 Knurled nut for closing screw
17 Shim
18 Fixing screw for basis
19 Stand pipe
20 Protecve cage safety screw + nut
Bekijk gratis de handleiding van Brandson 307510, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Brandson |
| Model | 307510 |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 5445 MB |
