Bosch WGB256A2GB handleiding
Handleiding
Je bekijkt pagina 47 van 60
en
47
Fault Cause and troubleshooting
E:38 -25 -26 Drain pump is blocked.
1.
Clean the drum. →Page40
2. If the fault persists, clean the drain pump.
→Page42
Inlet opening of the rubber gasket is blocked.
▶ Clean the inlet opening in the rubber gasket.
E:10 -00 -10 -20 The pump for the intelligent dosing system is blocked.
1.
Clean the detergent drawer. →Page40
2. If the fault persists, call customer service.
→Page54
Note:Until the fault is rectified, you can deactivate the
intelligent dosing system and dose manually.
→Page23
H:32 The appliance has interrupted the spin cycle because
the laundry is unevenly distributed.
▶ Redistribute the laundry in the drum.
E:30 -10 / The tap is turned off.
▶ Turn on the tap.
The water inlet hose is kinked or jammed.
▶ Check the installation of the water inlet hose.
→Page14
The filter in the water inflow is blocked.
▶ Clean the filter in the water inflow.
The water pressure is low.
▶ Check whether the tap has sufficient water pres-
sure.
The water level measuring system is defective.
With this error message, the appliance starts a drain-
ing process.
1. Wait approx. 5 minutes until the draining process
ends.
2. Restart the appliance.
If required, start the draining process again.
3. If the fault persists, call customer service.
→Page54
E:35 -10 The appliance is leaking.
1. Turn off the water tap.
2.
Call customer service. →Page54
Bekijk gratis de handleiding van Bosch WGB256A2GB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bosch |
| Model | WGB256A2GB |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 5085 MB |
