Handleiding
Je bekijkt pagina 9 van 24
Installation instructions en
and that all wires are connected to the correct termin-
als.
Wiring diagram
Observe the wiring diagram.
a Switch
b Blue wire
c Brown wire
d Terminal
e Ignition module
2.7 Gas connection
Only an officially authorised technician should connect
the appliance.
Before connecting the gas
Observe any special conditions imposed by local suppli-
ers (utilities).
During the planning stage, consider the position of
supply connections.
The cooktop must be connected to the gas supply
with upstream connection of an isolation valve in ac-
cordance with the respectively valid regulations. We
recommend that the isolation valve be fitted prior to
the cooktop to enable isolation of cooktop from gas
supply. The valve must be easily accessible at all
times.
Position of the inlet connection
Check whether the local connection conditions (gas
type) are compatible with the unit’s setting. The spe-
cifications of this cooktop are stated on the data label
located on the bottom of the cooktop base.
A duplicate data label is supplied for adhesion to an
accessible location near the hotplate if the data label
on the base of the hotplate cannot be accessed when
the hotplate is installed.
Gas connection R 1/2
1.
Fit the seal and the connecting piece R1/2 to the
gas connection on the appliance.
2.
Fit regulator (N. G.) or a test point (Universal LPG) dir-
ectly to the R1/2 connecting piece.
– Direction of gas flow is indicated on the rear of the
regulator.
– a: Pressure test point.
Connecting the unit to the gas line
The supply connection point shall be accessible with the
appliance installed.
Tip: Make sure that all connections performed are free
of leakage. Use pipe compound or thread sealant, prop-
erly threaded pipes and careful assembly procedure so
that there is no cross threading and so on, which might
cause damage or leakage.
The manufacturer does not accept any liability for leak-
age on connections performed by the installer or if the
L-tube is moved or twisted.
Refer to AS/NZS 5601.1 for piping size details.
Remove plastic cap from gas supply line prior to in-
stallation.
There are two ways to carry out the connection to the
main gas line:
– Connect with rigid pipe as specified in AS/NZS
5601.1.
9
Bekijk gratis de handleiding van Bosch PRS9A6H40A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bosch |
| Model | PRS9A6H40A |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2647 MB |
