Handleiding
Je bekijkt pagina 20 van 24
en Troubleshooting
15.1 Malfunctions
Fault Cause and troubleshooting
The general electrical operation is
impaired.
The circuit breaker is faulty.
Check the circuit breaker in the fuse box.
The circuit breaker or one of the residual-current circuit breakers has been
triggered.
In the fuse box, check whether the circuit breaker or one of the residual-current
circuit breakers has been triggered.
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
There has been a power cut.
Check whether the lighting in your room or other appliances are working.
Automatic ignition is not working. Food remnants or dirt are located between the ignition plug and the burner.
Clean the space between the ignition plugs and burners.
Burner parts are wet.
Carefully dry the burner parts.
The burner parts are positioned incorrectly.
Correctly position the burner parts.
The appliance is not earthed or has not been connected correctly, or the earth
cable is damaged.
Contact an electrician.
The burner flame is not uniform. The burner parts are positioned incorrectly.
Correctly position the burner parts.
Openings on the burner are soiled.
Clean and dry the openings on the burner.
The gas does not appear to be
flowing normally or there is no
gas being produced at all.
The gas supply has been shut off by the intermediate valves.
Open the intermediate valves.
The gas cylinder is empty.
Replace the gas cylinder.
There is a smell of gas in the kit-
chen.
The control knob is open.
Close the control knob.
The gas cylinder has not been connected correctly.
Ensure that the gas cylinder has been connected correctly.
The gas pipe to the appliance is leaking.
1.
Close the main gas tap.
2.
Ventilate the room.
3.
Immediately call an authorised installer, who can inspect the gas system and
issue an installation certificate.
4.
Do not use the appliance until you are sure that gas is not leaking from the in-
stallation or the appliance.
The burner switches off as soon
as you release the control knob.
Control knob not pressed down long enough.
1.
Keep the control knob pressed down for a few seconds after ignition.
2.
Press the control knob down firmly.
Openings on the burner are soiled.
Clean and dry the openings on the burner.
Automatic ignition is not working
and the , or
symbol appears in the display.
The electronics have overheated.
Switch the burners off or use only the lowest power level until the electronics
have cooled down sufficiently.
, , , , ,
appears on the display.
Electronics fault.
1.
Disconnect the cooktop from the mains.
2.
Wait a few seconds before reconnecting it.
3.
If the indicator continues to light up, contact the after-sales service.
HomeConnect is not working
properly.
Different causes are possible.
Go to
www.home-connect.com
.
The hood control is not working
properly.
The hood control functions do not switch on.
Resetting and re-pairing the settings of the Wi-Fi home network
20
Bekijk gratis de handleiding van Bosch PRS9A6H40A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bosch |
| Model | PRS9A6H40A |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2647 MB |
