Handleiding
Je bekijkt pagina 13 van 20
Basic operation en
Accessories Description Use
Additional wok grid Only use on the multi-crown burner.
Always use for cookware with a rounded
base.
Recommended in order to extend the ser-
vice life of the appliance.
Additional espresso maker
grid
Only use on the burner with the lowest
power setting.
Use with cookware with a diameter smaller
than 12.
Simmer cap Secure this above the economy burner cap.
Use only with the lowest power setting of
the burner.
Place the cookware on the pan support,
never directly on the simmer cap.
Simmer plate Use for cooking on a low heat.
Place it on the pan support with the bumps
facing up – never place it directly on the
burner.
Use the economy burner or the standard-
output burner. If you have multiple standard-
output burners, use the rear burner.
Basic operation7 Basic operation
7.1 Igniting a gas burner
The cooktop has automatic ignition of the burners.
WARNING‒Risk of fire!
Escaping gas may ignite.
If the burner does not ignite after 10seconds, turn
the control knob to the "Off" position and open the
door or window in the room. do not attempt to re-ig-
nite the burner for at least one minute.
In the event of the burner flames being accidentally
extinguished, turn off the burner control and do not at-
tempt to re-ignite the burner for at least one minute.
ATTENTION
If you turn the control knob directly between position
and1, malfunctions may occur.
For this reason, never turn directly from position to
position 1 or vice versa.
1.
Press the control knob for the selected burner and
turn it anti-clockwise to the highest level.
Keep the control knob pressed in.
For all of the burners, sparks are generated and the
flame ignites in the selected burner.
2.
Wait a few seconds and release the control knob.
"Safety system", Page13
3.
Turn the control knob to the required position.
4.
If the burner does not ignite, turn the control knob to
the off position and repeat the steps described
above. This time, hold the control knob down for
longer (up to 10 seconds).
Note
Take the following information into account to ensure
that the appliance works correctly:
The burner parts and the pan supports
Page12
must be inserted correctly.
Do not swap the burner caps around.
The burner holes and grooves must be clean to en-
sure a correct flame.
"Cleaning recommendations", Page15
7.2 Safety system
The safety system (thermocouple) prevents the flow of
gas if the flames accidentally go out. To ignite the
burner, you must activate the system that enables the
gas flow.
1.
Ignite the burner without releasing the control knob.
The flame ignites.
2.
Press and hold the control knob for a further four
seconds.
7.3 Igniting a gas burner manually
In the event of a power cut, you can light the burners
manually.
1.
Press the control knob for the selected burner and
turn it anti-clockwise to the highest level.
2.
Hold a lighter or a flame (lighter, match, etc.) against
the burner.
7.4 Switching off a burner
Turn the control knob clockwise to .
7.5 Normal behaviour during operation
This behaviour is normal for the appliance:
Slight hissing noise from the ignited burner.
Release of odours when using the appliance for the
first time. These odours disappear after a short time.
13
Bekijk gratis de handleiding van Bosch PPM9A6I40A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bosch |
| Model | PPM9A6I40A |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2062 MB |
