Bosch GRT 18V-40 Professional handleiding

Niet gecategoriseerd

Bosch

323 pagina's

PDF beschikbaar

Handleiding

/ 323

Je bekijkt pagina 39 van 323

English | 39

– Turn the Pro-Tap button(14) anticlockwise to wind the

line on to the spool (see arrows on the spool) until there is

about 15cm of spool line left on each side.

Anti-Tangle

The cutting tool is equipped with an anti-tangle function that

allows for continuous work without interruptions.

If the cutting tool is blocked, the motor automatically rotates

the spool clockwise for 3seconds to clear the blockage.

Once this is complete, the cutting tool will run anti-clockwise

again as usual.

If the blockage cannot be removed, the cutting tool will stop.

See chapter Troubleshooting for further support.

Troubleshooting

Problem Possible Cause Corrective Measure

Motor refuses to start Battery discharged Check the battery status indicator and charge the

battery

Battery too hot/cold Allow to cool/warm

Battery not fully inserted Ensure battery is inserted correctly

Grass wrapped around the spool Remove battery, then remove grass

Garden tool operates

intermittently

On/Off switch defective Contact Bosch customer service agent

Internal wiring of garden tool defective Contact Bosch customer service agent

Cutting head is blocked Remove the cutting head, clear any blockages and

reinsert the cutting head

Garden tool subject to

overload

Grass too high/dense

Cut in stages (see figureR)

Poor cutting perform-

ance

Garden tool subject to overload Move the device more slowly

Excessive cutting line

Rewind the line (see figureM) and check the cut-

ting blade

Protection guard encrusted with mud Clean inside of the protection guard

Garden tool does not

cut

Cutting line too short/broken off Feeding the cutting line using the Pro-Tap auto-

matism (see fig.M)

Spool empty

Replace the spool (see figureM)

Line retracts into spool Cutting line too short/broken off

Remove spool– rethread line (see figureM)

Line breaks frequently Line inside the spool entangled

Remove spool– rewind line (see figureM)

Trimmer used incorrectly Only trim with the tip of the line, avoid touching

stones, walls and other hard objects. Feed the

line regularly to maintain full cutting diameter.

Diameter of cutting thread is too small Use recommended cutting line

Heavy vibrations Cutting line broken

see figureM

Imbalance in the cutting head Remove any mud/contamination from the cutting

head. Check the cutting head and contact Bosch

customer service agent in case of damage

Spool incorrectly fitted

Insert all parts correctly (see figureY)

Protection guard incorrectly mounted Mount protection guard correctly

Blockage cannot be re-

moved by anti-tangle

function

Blockade is too heavy for the system to be re-

moved automatically and without manual assist-

ance

Remove the battery and remove the blockage

manually

Bosch Power Tools F 016 L94 625 | (12.11.2024)

/ 323

Bekijk gratis de handleiding van Bosch GRT 18V-40 Professional, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.