Bolin Technology EXU230H handleiding

Bewakingscamera

Bolin Technology

47 pagina's

PDF beschikbaar

Handleiding



2. GPI I/O Output Mode for Tally Signal Sent by Keyboard Controller:

a. Connect the camera to the keyboard using a standard RS-422 control cable.

b. Navigate to KEYBOARD SETTING > GPI I/O > Setting, and switch it to Output mode. Exit directly to the home menu.

c. After completing the above operation, you can switch between different cameras using the keyboard. For instance, selecting camera 1 on the keyboard

sends a tally signal to camera 1 via the standard RS-422 control cable. As a result, camera 1's tally light turns on, and thekeyboard gains control over camera

1's pan and zoom.

d. If you switch to camera 2 on the keyboard, the tally light for camera 2 will turn on, and the tally light for camera 1 will turn off.



Installing the Tally Light on the PTZ Camera



Follow these steps to install the tally light on yourPTZ camera:

1. Locating the Tally Light Port: The tally light port is located on the back of the camera, behind the camera’s handle, and is covered by a metal cover.

2. Unscrewing the Metal Piece: The metal cover should be carefully unscrewed to reveal the slot for the tally light. This metal piece is attached to the camera with

a small cable.

3. Attaching the Tally Light: The tally light should be aligned and inserted into the port. An arrow on the tally light indicates where to twist to secure it.

4. Replacing the Metal Cover: The metal cover that was removed earlier can now be attached underneath the tally light. As it is magnetic, it should attach easily

and stay in place.



Bekijk gratis de handleiding van Bolin Technology EXU230H, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.