Bolin Technology EXU230H handleiding

Bewakingscamera

Bolin Technology

47 pagina's

PDF beschikbaar

Handleiding

To connect a genlock signal to your camera, follow these steps:

1. Connect one end of a 75-ohm SDI cable with BNC connectors into the "Genlock" port of the camera.

2. Connect the other end of the 75-ohm SDI cable with BNC connectors to a device that is outputting the Genlock signal or providing timing reference(Sync

Generator, Video Switcher, Audio Mixer, etc...)

3. Open the camera's OSD menu and turn on External Synchronization. Other Genlock settings can be congured in this menu as well.



CAUTION:

Once the Genlock cable is connected, make sure to enable Genlock in the camera's menu. Otherwise, the camera may not be synchronized

with the rest of the system.

NOTE:

External synchronization is performed usingSDI only. Synchronization is not possible using the HDMI video signal or the IP video signal.



Tally Light



Tally Light GPI I/O connection

The camera is equipped with a removable tally light, serving as a visual indicator. When illuminated, this lightsignal that the camera is actively operational.To

activate the camera's Tally Light function, you need a video switch and a keyboard (not included).



GPI connection with RS422 VISCA control connection

Cable Conguration:

1. Set up a standardized RS-422 daisy chain control connection to seamlessly control multiple cameras from the keyboard controller. (For detailed RS422 control

information, refer to the Keyboard Controller user guide.)

2. Established a Tally/Contact Function cable connection between the Keyboard Controller and the Video Switcher (Sony).



1. On the keyboard side, connect pins 1-8. On the Video Switch side, connect pins 1-9, excluding pin 8.

2. Link keyboard pin 8 with video switch pin 9.

3. Connect keyboard pin 1 to video, switch pin 1, pin 2 to pin 2, and continue similarly (you can decide the rest based on the pattern), ensuring pin 7 is connected to

pin 7.



Set Up

1. GPI I/O Input Mode for Tally Signal from Video Switch:



a. Connect the camera to the keyboard using a standard RS-422 control cable.

b.Establish a connection between the keyboard and the video switch using a tally function cable.

c. Navigate to KEYBOARD SETTING > GPI I/O > Setting, and switch it to Input mode. Exit to the home directory.

d. After completing the above steps, you can switch between cameras using the video switch. For instance, selecting camera 1 on thevideo switch sends a

tally signal to the keyboard via the tally function cable. The keyboard then transmits this tally signal to camera 1 through the standard RS-422 control cable,

activating camera 1's tally light. The keyboard can now control camera 1's pan and zoom.

e. If you switch to camera 2 on the video switch, the tally light for camera 2 will turn on, and the tally light for camera 1 will turn off.



Bekijk gratis de handleiding van Bolin Technology EXU230H, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.