Blustream HDBaseT HEX100HDVGA-KIT handleiding
Handleiding
Je bekijkt pagina 6 van 10
HEX100HDVGA-KIT USER MANUAL
06
www.blustream.co.uk
The HEX100HDVGA can pass-through an RS232 signal for control of 3rd party equipment connected to either side of the TX and RX
units.
The HEX100HDVGA can also be set to receive an RS232 signal at either TX or RX end for the switching of the HDMI and VGA inputs
on the Transmitter unit.
The DIP switches on the side of both the Transmitter anbd Receiver units determine the mode and use of the RS232 connections
on both the TX and / or RX units.
RS232 Management
DIP POSITION 1 DIP POSITION 2 MODE
0 0
RS232 Pass through HDBaseT (default)
0 1
HDBaseT Firmware Update
1 0
Master Firmware Update
1 1
Switch between inputs via RS232 and al-
low RS232 pass through HDBaseT
RS232
Mode
1
0
12
BLUSTREAM RS-232 REMOTE CONTROL
CONSOLE
PIN Assignment PIN Assignment
1 NC 1 NC
2 Tx 2 Rx
3 Rx 3 Tx
4 NC 4 NC
5 GND 5 GND
6 NC 6 NC
7 NC 7 NC
8 NC 8 NC
9 NC 9 NC
Baud Rate: 9600 bps
Data Bit: 8-bit
Parity: None
Stop Bit: 1-bit
Flow Control: None
CODE DESCRIPTION
vgaselect Switch to VGA input
hdmiselect Switch to HDMI input
getselect
Get status of currently selected input, return message
will be HDMI port of VGA port
ensigdet Enable signal detect (auto switching)
dissigdet Disable signal detect (auto switching)
resetdef Restore factory settings
RS232 Control
RS232 switching codes for VGA and HDMI inputs:
Bekijk gratis de handleiding van Blustream HDBaseT HEX100HDVGA-KIT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Blustream |
| Model | HDBaseT HEX100HDVGA-KIT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1150 MB |
