Blomberg LDF31310W handleiding
Handleiding
Je bekijkt pagina 35 van 48

EN / 35
Care to avoid opening of the door
while the dishwasher is being oper-
ated. If you need to open the door,
stop the dishwasher by pressing
the Start / Hold / Cancel key. Then
open the door of the dishwasher.
Be careful as steam may come out
when you open the dishwasher’s
door. Press the Start / Hold / Can-
cel key again after closing the dish-
washer door. Cycle shall be re-
sumed.
After rinsing, the dishwasher will be
quiet for a while in pause mode
then will proceed to the drying step
to drain all the water left on the
dishes and inside the dishwasher
and to clean the water softener.
a
7.5 Cancelling the Cycle
1.Press the Start / Hold / Cancel key for 3
seconds to cancel the cycle.
2.Release the key when the Program indic-
ator starts flashing. The dishwasher will ex-
ecute the necessary operations for a few
minutes to cancel the program.
Detergent or rinse aid may remain
inside the dishwasher and/or the
dishes being washed as per the
step of the cycle you have can-
celled.
7.6 Low Salt Warning Indicator
Check the low salt indicator on the screen
of your dishwasher to see if you have
softening salt in your dishwasher. Add salt
to the salt reservoir when the low salt indic-
ator on the display comes on.
The Water Softening System sec-
tion describes how to set the water
hardness level.
7.7 Low Rinse Aid Warning Indic-
ator
Check the low rinse aid indicator on the
screen of your dishwasher to see in you
have enough rinse aid in your dishwasher.
Add rinse aid to the rinse aid reservoir
when the low salt indicator on the display
comes on.
7.8 Setting the Rinse Aid Amount
1.Press the Delay and P keys for 3 seconds
and enter the settings menu after turning
your dishwasher on.
2.Press the P key until the drying indicator
starts flashing.
3.Set to a proper level with the Delay key.
4.Press the On/Off key to save the setting.
Applies no rinse aid in P:1 position during
washing programme.
Applies 2 dose of rinse aid in the P:1 posi-
tion.
Applies 3 dose of rinse aid in the P:2 posi-
tion.
Applies 4 dose of rinse aid in the P:3 posi-
tion.
Applies 5 dose of rinse aid in the P:4 posi-
tion.
7.9 End of Cycle
Program End indicator illuminates when the
washing program has ended.
1.Turn your dishwasher off by pressing the
On / Off key.
2.Switch off the tap.
3.Remove the plug from the outlet.
Your dishwasher turns off automat-
ically after a certain period to save
energy when the cycle is ended or
not started.
After washing your dishes, keep
them inside the dishwasher for ap-
proximately 15 minutes to cool.
Your dishes will dry faster if you
leave the door of your dishwasher
ajar during this time. This will im-
prove the drying efficiency of the
dishwasher
Bekijk gratis de handleiding van Blomberg LDF31310W, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Blomberg |
Model | LDF31310W |
Categorie | Vaatwasser |
Taal | Nederlands |
Grootte | 5772 MB |