Blizzard Outpost Ranger RGBALC handleiding

24 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 13 van 24
Page 13
Outpost™ Ranger RGBALC - Rev. A © 2024 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Setting the DMX Address:
1.) The default mode for the xture is DMX, which appears as 001 on the OLED readout.
To select a dierent DMX address, using the <MENU> button, select Address, then hit
<ENTER>. Use the <UP/DOWN> buttons to select the correct address, then hit <ENTER>
to conrm.
Setting the DMX Channel Mode:
1.) To select a DMX channel mode, press the <MENU> button, then use the <UP/DOWN>
buttons until the display reads Set and press the <ENTER> button. Then use the <UP/
DOWN> buttons until the display reaches Ch. Mode, and press <ENTER>. Now press the
<UP/DOWN> buttons again to highlight your desired DMX channel mode, and press the
<ENTER> button to conrm.
Slave Mode:
1.) Daisy chain the DMX in/out connections on all xtures.
2.) There is nothing else to it! The rst xture in the DMX chain is the master xture, and the
other xtures down the line will follow it.
Using CRMX Wireless DMX
This xture is equipped with a LumenRadio-compatible wireless 2.4 GHz frequency CRMX receiver
that allows for stable and easy-to-setup wireless DMX connections. Please refer to your specic CRMX
transmitter for further instructions.
Steps to Connect:
1.) Ensure your transmitting device is broadcasting a CRMX wireless signal.
2.) Navigate to the xture's menu and go to Set > Source > Unlink. Conrm if you wish to
unlink from any previous connection.
3.) From the Source sub-menu, select 2.4G.
4.) Once the xture is paired, the wireless status LED will illuminate BLUE. When receiving DMX,
the LED will turn PURPLE.
Setup Examples:
1.) One transceiver with multiple receiver setups:
a.) Power on all units.
b.) On the receiving xtures, follow the previous instructions to pair them with the
transmitting unit.
2.) Multiple transceiver setups, with multiple receivers; e.g. 3 groups consisting of a transceiver
& receiver(s) named A, B, and C:
a.) Turn power o of all units.
b.) Group “A” gets powered on, then follow step 1 above.
c.) Group “B” gets powered on, then follow step 1 above.
d.) Group “C” gets powered on, then follow step 1 above.

Bekijk gratis de handleiding van Blizzard Outpost Ranger RGBALC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkBlizzard
ModelOutpost Ranger RGBALC
CategorieNiet gecategoriseerd
TaalNederlands
Grootte2695 MB