Black Box SW1046A handleiding
Handleiding
Je bekijkt pagina 19 van 28
877-877-2269 | BLACKBOX.COM
Page 19
Chapter 7: Console Commands
SET TELNETPORT N
GET TELNETPORT
Set or display the current telnet port number. Changing the telnet port number from the default can be used to
provide an additional level of security. Any change will not become permanent until a SAVE and RESET
operation sequence is performed.
SET MONITORIP [X.X.X.X]
GET MONITORIP
Set or display the IP address of the device that the A/B Switch is to PING to determine the active port alternate
(A) or normal (B). Setting this to 0.0.0.0 disables the auto switch/recovery function. Any change will not become
permanent until a SAVE operation is performed. The MONITORIP is the IP address used to control an optional
auto recovery function. If enabled, the auto switch/recovery function will PING the monitor IP address. When the
PING is successful, the A/B Switch will auto-switch to the normal path (B), connecting port B to the common
port C. When the PING is not successful, the A/B Switch will auto-switch to the
alternate path (A), connecting port A to the common port C.
SET MONITORMAC [X X X X X X]
GET MONITORMAC
Set or display the MAC (Ethernet) address of the device that the A/B Switch is to PING to determine the active
port switch (A) or normal (B). This value is entered as a series of six HEX characters with spaces between each
HEX character. If monitoring connectivity to a device on the same subnet as the A/B Switch internal Ethernet
node, set the monitormac address parameters to the MAC address of the device being monitored. If monitoring
connectivity to a device on a different subnet/network than the A/B Switch internal Ethernet node, set the
monitormac address parameter to the MAC address of the gateway router on the A/B Switch subnet. If the
monitormac address is set to 00 00 00 00 00 00, the A/B Switch will automatically determine the proper MAC
address required for the PING packet by issuing an ARP request to the gateway router. Any change will not
become permanent until a SAVE operation is performed.
SET MONITORINTERVAL [N]
GET MONITORINTERVAL
Set or display the time interval between PINGs issued by the internal Ethernet node in the A/B Switch,
measured in 100 msec increments. To issue PINGs every 1.5 seconds, set this value to 15. The valid range is 1 to
255 (0.1 seconds to 25.5 seconds). A value of 0 disables the automatic switch/recovery function. Any change will
not become permanent until a SAVE operation is performed.
SET MONITORFAILCOUNT [N]
GET MONITORFAILCOUNT
Set or display the number of successive PING attempts that must fail before the A/B Switch automatically
switches to the alternate path and removes the normal path connection path. The valid range is 1 to 255. A
value of 0 disables the automatic switch/recovery function. Any change will not become permanent until a
SAVE operation is performed.
Bekijk gratis de handleiding van Black Box SW1046A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Black Box |
| Model | SW1046A |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3336 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Gewicht | 1800 g |
| Breedte | 159 mm |
| Diepte | 205.7 mm |
| Hoogte | 64 mm |
