Bernette b38 Yaya Han Edition Handleiding (70 Pagina's)

Handleiding

68

Warning sign Cause Try this

1. The start/stop button is pressed with the foot control con-

nected.

2. The foot control is out of order.

(The foot control sign keeps blinking. )

Disconnect the foot control.

Contact the service center or

the store from whom the

machine was purchased.

The machine is started the with the presser foot raised. Lower the presser foot and

start the machine again.

The machine will stop if the buttonhole is sewn without lowering

the buttonhole lever.

Lower the buttonhole lever and

start the machine again.

The bobbin winder spindle is shifted to the right. Shift the bobbin winder spindle

to the left for stitching.

The machine is started after halting due to overload. Wait for at least 15 seconds to

restart.

Switch off the power switch.

Remove tangled threads

around take-up lever, hook

race.

(E1-E7) The machine does not work properly due to a problem in the

control circuit.

Contact the service center or

the store from whom the

machine was purchased.

It is normal that a faint humming sound comes out from inside the machine.

LCD display may get warm when the machine has been used for hours.

Audible signal The buzzer sounds when:

Pip Normal operation.

Pip-pip-pip Invalid operation or malfunction.

Peep All memorized stitch patterns are cleared.

E1-E7 error occurred.

Pip-Peep Buttonhole is completed

Problems and Warning Signs

If a buzzer sounds and the LCD display shows a warning sign, follow the guidance below.

Bekijk gratis de handleiding van Bernette b38 Yaya Han Edition, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.