Baofeng UV-5RM PLUS GPS handleiding
Handleiding
Je bekijkt pagina 23 van 49
In frequency mode, the frequency sweep range can be precisely set. Input the start value and end value of the sweep frequency through the
keyboard.
EX: Enter 144146, in frequency mode, scan in the range of 144.000-146.000MHZ. Enter 430440, in frequency mode, scan in the range of
430.000-440.000MHZ.
Note: for VFO frequency Ranger, see Menu>SCAN>Freq Ranger.
6.1.2 Channel Scan Range
In channel mode, the scan range is allowed to be all channels in the current zone, channels that have been added to the current zone.
-All: All channels stored in the current zone.
-Memory Scan: Scanned channels that are added to the current zone.
6.1.3 Scan modes
The scanner is configurable to one of three ways of operation: Time, carrier or search, each of which is explained in further details in their
respective section below.
Time operation
In Time Operation (TO) mode, the scanner stops when it detects a signal, and after a factory preset time out, it resumes scanning.
Carrier operation
In Carrier Operation (CO) mode, the scanner stops when it detects a signal, and after a factory preset time with no signal it resumes
scanning.
Search operation
In Search Operation (SE) mode, the scanner stops when it detects a signal.
To resume scanning you must press and hold the
key again.
Note: for Scan mode, see Menu>SCAN>Scan Mode.
6.1.4 Scan Sub-Code
To search for a CTCSS code, do the following:
(1) In VFO mode, enter a known frequency, such as 144.525.
(2) Press
key to enter menu>>Scan>>Scan Sub-Code.
Bekijk gratis de handleiding van Baofeng UV-5RM PLUS GPS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Baofeng |
| Model | UV-5RM PLUS GPS |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6082 MB |
