Baby Lock Regalia Longarm handleiding
Handleiding
Je bekijkt pagina 66 van 71
66 | www.BabyLock.com
The needle is not posioned
properly
• Posion the needle properly to the needle bar. Inspect the
posion of the needle to make sure the needle is at the 6 o’clock
posion. When you stand directly in front of the needle (facing the
bobbin case side of the machine), you will see the enre needle
eye directly facing you. This is 6 o’clock posion.
• Make sure (a) the needle is installed all the way into the needle
bar to the needle-stop hole, (b) the long groove in the needle is
toward the front (bobbin case side), and (c) the scarf (scooped out
part of the back of the needle) is toward the back of the machine.
• The needle can somemes be rotated to 5 o’clock (slightly right)
or 7 o’clock (slightly le) to adjust for a more posive thread loop
pickup by the hook point.
The Needle Breaks Correcve Measure(s)
The needle is bent or not
installed properly
• Replace the needle. Make sure that the needle is pushed into the
needle bar clamp unl it can go no further. Visually check that it is
up to the top of the sight hole above the needle bar clamp screw.
If the needle isn’t installed properly, it can cause damage in the
bobbin area and throat plate.
The needle hits the throat plate • Correctly posion the needle, throat plate, or hopping foot.
Replace with a new needle.
Stches are Puckered Correcve Measure(s)
The tension is not balanced • Balance the tension of the needle thread aer ensuring the
bobbin tension is adjusted correctly. (For more informaon about
adjusng tension, see Bobbin and Bobbin Tension and Quick-Set
Tension™ in the Using Your Machine secon of this manual.)
Needle too large for
quilng fabric
• Replace the needle with a size beer suited for the fabric.
Poor Stch Quality Correcve Measure(s)
The tension is not balanced • Balance the tension of the needle thread aer ensuring the
bobbin tension is adjusted correctly. (For more informaon about
adjusng tension, see Bobbin and Bobbin Tension and Quick-Set
Tension™ in the Using Your Machine secon of this manual.)
Bobbin case is damaged,
corroded, dirty, etc.
• Since thread slides over the surface of the bobbin case at a high
speed, make sure the case is free of any lint or foreign maer that
could impede thread passage through the machine.
Moving the machine too fast
for needle speed selected
(Manual mode)
• Synchronize machine movement and needle speed to get your
desired stch length. Elongated stches are an indicaon of
moving the machine too fast for the current speed.
Bekijk gratis de handleiding van Baby Lock Regalia Longarm, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Baby Lock |
| Model | Regalia Longarm |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 20188 MB |
