Baby Lock Gallant Longarm handleiding
Handleiding
Je bekijkt pagina 20 van 58
20 | www.BabyLock.com
Gallant Ruler Base
If you plan to use rulers and templates with your Gallant, you will need to aach the ruler base to give
you a large, stable surface on which to rest the ruler or template. The ruler base, rulers, and templates are
oponal accessories.
To install the ruler base
1. The Ruler Base Kit comes with four posts for the
ruler base that you will aach to the machine using
the 4 screws.
2. Guide the wide part of the latches back unl they are
between the front and rear ruler base posts. Then
lower the ruler base down between the posts.
3. Push the ruler base back unl it is touching the
machine or snaps into place.
NOTE: When the wide part of the latch is down between the two posts there will sll be a gap
between the ruler base opening and the front of the machine. Push back on the ruler base to
secure it into place
To remove the ruler base
• Grasp the front corners of the ruler base. Pull the ruler base towards you and then up and away from
the machine.
To use rulers and templates with your quilng machine
U CAUTION: Use only 1/4 inch thick rulers with your machine. Do not use rotary-cung rulers;
they are too thin and can easily slip under the hopping foot. Always use the Gallant Ruler Base to
stabilize the ruler. The 1/4-inch Ruler Foot in the Ruler and Echo Foot Set will give an extra measure
of security while using rulers.
Keep the ruler at and quilt only where the ruler is held securely. Avoid losing control by walking your hand
along the ruler or stopping and reposioning your hand and/or the ruler.
• Quilng with rulers requires gentle three-point pressure as follows:
1. Posion and press the ruler against any side of the hopping foot.
2. Press machine against ruler.
3. Press ruler against ruler base with only as much force as is necessary to keep the ruler from
slipping. Too much pressure will prevent the machine from moving.
The quilng line will be approximately 1/4 inch away from the ruler edge. The markings on all Baby Lock
rulers take this into consideraon.
NOTE: Set the machine to stop in the needle-down posion to keep the machine from moving while
making adjustments with the ruler.
Bekijk gratis de handleiding van Baby Lock Gallant Longarm, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Baby Lock |
| Model | Gallant Longarm |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12386 MB |
