Axxess AXI-TL10-R handleiding
Handleiding
Je bekijkt pagina 10 van 12
10
Plug & Play Harness Installation
PLUG & PLAY AXi-TL10-R HARNESS INSTALLATION:
All connections of the AXi-TL10-R plug and play installation harness in
TOYOTA/LEXUS vehicles are done at the navigation DVD-ROM.
Step 1: Locate TOYOTA/LEXUS DVD‐ROM and gain access to the connectors,
see page 5 for the DVD-ROM location.
Step 2: Disconnect white 10‐pin connector from back of the navigation
DVD‐ROM computer.
Step 3: Insert male connector of the AXi-TL10-R plug‐and‐play harness back
into the navigation DVD‐ROM computer.
Step 4: Insert previously disconnected factory 10‐pin connector into female
connector of AXi-TL10-R plug‐and‐play harness.
Step 5: Connect AXi-TL10-R plug‐and‐play harness to the universal
AXi-UNIHAR-R harness supplied with AXi-RGB1/AXi-RGB2/AXi-RGB3.
Step 6: Connect black ground wire of AXi-UNIHAR-R harness directly to
chassis ground of the DVD-ROM ground wire. (see table 1 on pages 4-5)
Step 7: Connect red wire of AXi-UNIHAR-R harness to a +12v accessory
power source in the vehicle. (see table 1 on pages 4-5)
Step 8: Connect gray wire of AXi-UNIHAR-R harness to emergency brake in
the vehicle. (connection is not required if only installing the back-up camera)
Step 9: Connect orange wire of AXi-UNIHAR-R harness to a reverse light in
the vehicle. (see table 1 on pages 4-5) If an aftermarket back-up camera is
not going to be installed or vehicle is already equipped with a factory back-up
camera, DO NOT connect Orange wire.
Step 10: Connect yellow wire of AXi-UNIHAR-R harness to the push button
switch, and connect other side of the push button switch to a +12V accessory
power source. (connection is not required if only installing back-up camera)
Momentary normally open push button should be used for this purpose.
Step 11: Connect AXi-UNIHAR-R harness to AXi-RGB1/AXi-RGB2/AXi-RGB3
AXXESS.i video interface.
If installing an aftermarket back up camera connect it to video input 2, If an
external video source is being installed connect it video 1 input.
If installing AXi-RGB2/AXi-RGB3 and blue wire is not used, insulate the end of
blue wire with electrical tape.
If installing AXi-RGB3 with HDMI video source you have an option of audio
output via 3.5 mm audio jack located next to the main interface plug.
Bekijk gratis de handleiding van Axxess AXI-TL10-R, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXI-TL10-R |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1322 MB |
