Axxess AXGMLN-09 handleiding
Handleiding
Je bekijkt pagina 3 van 4
3
REV. 4/22/24 INSTAXGMLN-09
AXSWC CONNECTIONS
I N STALL ATI O N
With the key in the off position:
1.
Connect the 16-pin harness with stripped leads, and the AXGMLN-09 harness, into the
AXGMLN-09 interface.
2. If an AXSWC (sold separately) will be used, do not connect it until the AXGMLN-09 is
programmed and fully functional.
3. If an AXM50-GM1 (sold separately) will be used, REFER to AXM50-GM1 wiring/programming
instructions.
Attention! Do not connect the AXGMLN-09 harness to the wiring harness in the vehicle yet
For the steps below, the L.E.D. located inside the AXGMLN-09 interface can only be seen while
active. The interface does not need to be opened to see the L.E.D.
1. Start the vehicle.
2. Connect the AXGMLN-09 harness to the wiring harness in the vehicle. The L.E.D. will initially
be Green to indicate the interface is powered.
Note: For the Equinox and Malibu, use part number AXEXH-GM09 (sold separately) to
extend the wiring harness to the right of the glovebox where the radio brain is located at.
3.
After a few seconds the L.E.D. will turn on solid Red while the interface automatically programs
to the vehicle. The radio will shut off at this point. This process should take 5 to 30 seconds
.
4. After the interface is programmed, the L.E.D. will turn on solid Green, and the radio will
come back on, indicating programming was successful.
5. Test all functions of the installation for proper operation, before reassembling the dash.
Note: The vehicle must be running for the factory camera to power on.
6. If the interface fails to function, refer to the Troubleshooting section.
12-pin AXSWC harness & 3.5mm jack:
The 12-pin AXSWC harness & 3.5mm jack are to be used with an AXSWC (sold separately)
to retain steering wheel audio controls. If the AXSWC is not being used, disregard this
harness and 3.5mm jack. If it is to be used, please refer to the AXSWC instructions for radio
connections and programming. Disregard the harness that comes with the AXSWC.
• Connect the 4-foot long Green/Black wire to the Green/Black steering wheel control wire
located in the steering column, at the top left. (Figure A)
(Figure A)
Green/Black wire
PROGRAMMING
Bekijk gratis de handleiding van Axxess AXGMLN-09, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXGMLN-09 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 638 MB |
