Axxess AXGMLN-08 handleiding
Handleiding
Je bekijkt pagina 3 van 8
AXGMLN-08
3
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the AXGMLN-08 harness,
into the interface.
• Connect the AXGMLN-08 harness to the wiring harness in the vehicle.
Note: If using the AXSWC, connect it after you initialize and test the
AXGMLN-08, with the key in the off position.
OnStar Level Adjustment
• Press the OnStar button to activate it.
• While OnStar is speaking, press the VOLUME UP or VOLUME DOWN button on
the steering wheel to raise or lower the OnStar level.
• If the vehicle does not come equipped with steering wheel controls, locate the
Black/Yellow
wire on the AXGMLN-08 harness.
•
While OnStar is speaking, tap the Black/Yellow wire to ground. Once the OnStar level
is set, it will stay at that level until the Black/Yellow wire is tapped to ground again
.
Attention! If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an AXSWC connect it after you initialize and
test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation, before reassembling the dash.
Initializing the AXGMLN-08
Installing the AXGMLN-08 Adjusting the AXGMLN-08
Bekijk gratis de handleiding van Axxess AXGMLN-08, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXGMLN-08 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 991 MB |
