Axxess AXGM-07 handleiding
Handleiding
Je bekijkt pagina 3 van 8
AXGM-07
3
Installing the AXGM-07
Initializing the AXGM-07
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the AXGM-07 harness, into
the interface.
• Connect the AXGM-07 harness to the wiring harness in the vehicle.
Attention! If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an AXSWC connect it after you initialize and
test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation, before reassembling the dash.
Adjusting the AXGM-07
Chime level adjustment:
• Turn the vehicle off but leave the keys in the ignition. Open the driver’s door and
leave it open; chimes will be heard.
• Wait 10 seconds, and then with a small flat-blade screwdriver, adjust the
potentiometer clockwise to raise the chime level; counterclockwise to lower the
chime level.
Note: The potentiometer is located on the side of the interface where the 16-
pin harness with stripped leads is connected to.
• When the chime is at the desired level, remove the keys from the ignition. This
will lock the chime level in at its current level.
OnStar level adjustment:
• Press the OnStar button to activate it.
• While OnStar is speaking, press the VOLUME UP or VOLUME DOWN buttons on
the steering wheel to raise or lower the OnStar level.
• If the vehicle does not come equipped with steering wheel controls, locate the
Black/Yellow wire on the AXGM-07 harness.
• While OnStar is speaking, tap the Black/Yellow wire to ground. Once the
OnStar level is set, it will stay at that level until the Black/Yellow wire is tapped
to ground again.
Bekijk gratis de handleiding van Axxess AXGM-07, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXGM-07 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 917 MB |
