Axxess AXDIS-MZ1 handleiding
Handleiding
Je bekijkt pagina 3 van 8
3
REV. 11/22/24 INSTAXDIS-MZ1
CONNECTIONS TO BE MADE (CONT)
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire
• Tape off and disregard the following (3) wires, they will not be used in this application:
Brown, Orange/White, Red
From the AXDIS-MZ1 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Blue wire to the power antenna wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Tape off and disregard the following (4) wires, they will not be used in this application:
Green, Green/Black, Purple, Purple/Black
Note:
The 2’ long harness with a 24-pin connector is a service harness for setting the clock with
the factory radio. Please run this harness to a location where it can be easily accessed, yet hidden
.
Continue to 3.5mm jack steering wheel control retention
Attention! This interface will work with models that are either factory amplified, or non-
amplified. Please follow the instructions carefully for your model vehicle. Failure to do so will
result in either no sound, or low sound. If you are unsure if your vehicle is factory amplified or
not, please contact your local dealership.
For models
with
an amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
Bekijk gratis de handleiding van Axxess AXDIS-MZ1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXDIS-MZ1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 895 MB |
