Axxess AXDIS-GMLN44 handleiding
Handleiding
Je bekijkt pagina 7 van 12
7
REV. 11/1/24 INSTAXDIS-GMLN44
PROGRAMMING THE AXDIS-GMLN44
ADJUSTING THE AXDIS-GMLN44
For the steps below, the LED located inside the interface can only be seen while active. The
interface does not need to be opened to see the LED.
1.
Start the vehicle.
2. Connect the AXDIS-GMLN44 harness to the wiring harness in the vehicle.
3. The LED will initially turn on solid Green, then turn off for a few seconds while it auto
detects the radio installed.
4. The LED will then flash Red up to (24) times indicating which radio is connected to the interface,
and then turn off for a couple of seconds. Pay close attention to how many Red flashes there
are. This will help in troubleshooting, if need be. Refer to the LED Feedback section for more
information.
5. After a couple seconds the LED will turn on solid Red while the interface auto detects
the vehicle. The radio will shut off at this point. This process should take 5 to 30
seconds.
6. Once the vehicle has been auto detected by the interface, the LED will turn on solid
Green, and the radio will come back on, indicating programming was successful.
7. Test all functions of the installation for proper operation, before reassembling the dash.
If the interface fails to function, refer to Resetting the AXDIS-GMLN44.
Note:
The LED will turn on solid Green for a moment, and then turn off under normal
operation after the key has been cycled.
Audio level adjustment (digital amplified models only):
• With the vehicle and radio turned on, turn the volume up 3/4 of the way.
• With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio
level; counterclockwise to lower the audio level.
• Once at a desired level, audio level adjustment is complete.
Chime level adjustment (digital amplified models only):
• With the vehicle on, turn it off and leave the keys in ignition. Open the driver’s door; chimes
will be heard.
• Wait 10 seconds, and then with a small screwdriver, turn the potentiometer clockwise to
raise the chime level; counterclockwise to lower the chime level.
• When the chime is at a desired level, remove the keys from the ignition. This will lock the
chime volume at its current level.
OnStar
®
Level Adjustment
• Press the OnStar
®
button to activate it.
• While OnStar
®
is speaking, press the VOLUME UP or VOLUME DOWN button on the steering
wheel to raise or lower the OnStar
®
level.
• If the vehicle does not come equipped with steering wheel controls, locate the Black/
Yellow wire on the AXDIS-GMLN44 harness.
• While OnStar
®
is speaking, tap the Black/Yellow wire to ground. Once the OnStar
®
level is
set, it will stay at that level until the Black/Yellow wire is tapped to ground again.
Bekijk gratis de handleiding van Axxess AXDIS-GMLN44, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXDIS-GMLN44 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1230 MB |
