Axxess AXDI-GMLN10 handleiding
Handleiding
Je bekijkt pagina 3 van 4
3
REV. 06/03/2025 INSTAXDI-GMLN10
I N STALL ATI O N
PROGRAMMING
With the key in the off position:
1. Locate the factory radio harness in the vehicle and complete all necessary connections to the
aftermarket radio.
2. Connect the AXDI-GMLN10 harness to the AXDI-GMLN10 interface, and then to the factory
radio harness in the vehicle.
Note: For the Equinox and Malibu, use part number AXEXH-GM10 (sold separately) to extend the
wiring harness to the right of the glovebox where the radio brain is located.
Attention: If the interface loses power for any reason, the following steps will need to be
performed again.
1.
Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on
.
Note: If the radio does not come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
2. Cycle the key off, then back on. If the driver’s door is closed, open and close the door.
3. Test all functions of the installation for proper operation, before reassembling the dash.
Note: The vehicle must be running for the factory camera to power on.
Bekijk gratis de handleiding van Axxess AXDI-GMLN10, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXDI-GMLN10 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 452 MB |
