Axxess AXDI-GLMLN29 handleiding
Handleiding
Je bekijkt pagina 3 van 4
AXDI-GLMLN29
3
Connections to be made (Cont)
Installing the AXDI-GLMLN29
Initializing the AXDI-GLMLN29
With the key in the off position:
• Connect the AXDI-GLMLN29 harness into the interface, and then to the wiring
harness in the vehicle.
Note: If using the AXSWC, connect it after you initialize and test the AXDI-
GLMLN29, with the key in the off position.
Attention! If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an AXSWC connect it after you initialize and
test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation, before reassembling the dash.
12-pin pre-wired AXSWC harness:
• This harness is to be used along with the optional AXSWC (not included) to
retain steering wheel audio controls. If the AXSWC is not being used, disregard
this harness. If it will be used, please refer to the AXSWC instructions for radio
connections and programming.
Note: Disregard the harness that comes with the AXSWC.
Bekijk gratis de handleiding van Axxess AXDI-GLMLN29, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXDI-GLMLN29 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 481 MB |
