Axxess AXBUCH-T16V handleiding
Handleiding
Je bekijkt pagina 2 van 8
2
CONNECTIONS
The AXBUCH-T16V can be connected two different ways:
To retain the factory backup camera to an aftermarket radio, connect as indicated:
• Black wire to chassis ground, and also to the Black wire of the AXCSD-6V.
• Yellow wire to the Blue/Red wire of the AXCSD-6V.
• Reverse wire from the aftermarket radio, to the reverse signal in the vehicle, and also to
the Blue/White wire of the AXCSD-6V.
• Yellow RCA jack (male) to the rear camera input of the aftermarket radio.
• Disregard the loose Green/Purple wire, it will not be used in this application.
To allow an aftermarket camera to be added to the OEM screen:
• Black wire to the ground wire of the aftermarket camera.
• Power wire of the aftermarket camera to accessory power.
• Tape off and disregard the Yellow wire, it will not be used in this application.
• Yellow RCA (female) jack to the aftermarket camera.
• The AXCSD-6V 12-volt to 6-volt converter will not be used in this application.
14 13 12 11 10 9 8 7 6 5 4 3 2 1
28 27 26 25 24 23 22 21 20 19 18 17 16 15
The following (2) steps are only required if a wire is not present in the factory harness.
*Except Avalon 2013-2014 and Venza 2013-2014
• If a wire is not present in pin-2 of the 28-pin connector of the factory radio, unplug the
connector, then insert the metal pin of the loose Green/Purple wire into it. Connect the
harness back into the radio.
• Connect the other end of the loose Green/Purple wire to the reverse wire of the vehicle.
This is the wire view of the connector in the vehicle.
28 Pin Harness
Bekijk gratis de handleiding van Axxess AXBUCH-T16V, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXBUCH-T16V |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 797 MB |
