Axxess AXBUCH-MZ6V handleiding

2 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 2 van 2
AXBUCH-MZ6V AXBUCH-MZ6V
INSTALLATION INSTRUCTIONS
AXBUCH-MZ6V AXBUCH-MZ6V
INSTALLATION INSTRUCTIONS
REV. 6/18/25 REV. 6/18/25
© COPYRIGHT 2025 METRA ELECTRONICS CORPORATION © COPYRIGHT 2025 METRA ELECTRONICS CORPORATION
Integrate • AxxessInterfaces.com Integrate • AxxessInterfaces.com
REV. 6/18/25 REV. 6/18/25
© COPYRIGHT 2025 METRA ELECTRONICS CORPORATION © COPYRIGHT 2025 METRA ELECTRONICS CORPORATION
Integrate • AxxessInterfaces.com Integrate • AxxessInterfaces.com
INSTRUCCIONES DE INSTALACIÓN
INSTRUCCIONES DE INSTALACIÓN
Metra recommends MECP
certified technicians
Connections to be made
The AXBUCH-MZ6V can be connected two different ways
To retain the factory backup camera to an aftermarket radio:
Connect the Black wire to chassis ground, and also to the Black wire of the AXCSD-6V.
Connect the Yellow wire to the Blue/Red wire of the AXCSD-6V.
Connect the reverse wire from the aftermarket radio, to the reverse signal in the vehicle,
and also to the Blue/White wire of the AXCSD-6V.
Connect the
male
Yellow RCA jack to the rear camera input of the aftermarket radio.
To allow an aftermarket camera to be added to the OEM screen:
Connect the
female
Yellow RCA jack to the aftermarket camera.
The AXCSD-6V 12-volt to 6-volt converter will not be used in this application.
Tape off and disregard the following (2) wires, they will not be used in this application;
Black, Yellow
Connections to be made
The AXBUCH-MZ6V can be connected two different ways
To retain the factory backup camera to an aftermarket radio:
Connect the Black wire to chassis ground, and also to the Black wire of the AXCSD-6V.
Connect the Yellow wire to the Blue/Red wire of the AXCSD-6V.
Connect the reverse wire from the aftermarket radio, to the reverse signal in the vehicle,
and also to the Blue/White wire of the AXCSD-6V.
Connect the
male
Yellow RCA jack to the rear camera input of the aftermarket radio.
To allow an aftermarket camera to be added to the OEM screen:
Connect the
female
Yellow RCA jack to the aftermarket camera.
The AXCSD-6V 12-volt to 6-volt converter will not be used in this application.
Tape off and disregard the following (2) wires, they will not be used in this application;
Black, Yellow
IMPORTANT
If you are having difficulties with the installation of this product, please call our Tech Support
line at 386-257-1187. Before doing so, look over the instructions a second time, and make
sure the installation was performed exactly as the instructions are stated. Please have the
vehicle apart and ready to perform troubleshooting steps before calling.
IMPORTANT
If you are having difficulties with the installation of this product, please call our Tech Support
line at 386-257-1187. Before doing so, look over the instructions a second time, and make
sure the installation was performed exactly as the instructions are stated. Please have the
vehicle apart and ready to perform troubleshooting steps before calling.
Conexiones que se deben hacer
El AXBUCH-MZ6V puede conectarse de dos maneras distintas
Para retener la cámara de reversa de fábrica para un radio de mercado secundario:
Conecte el cable negro a la tierra del chasis, y también para el cable negro del AXCSD-6V.
Conecte el cable amarillo al cable azul/rojo del AXCSD-6V.
Conecte el cable de marcha atrás del radio de mercado secundario, a la señal
de marcha atrás en el vehicle, y también para el cable azul/blanco de la AXCSD-6V.
Conecte el conector RCA
macho
amarillo RCA en la entrada de la cámara de reversa del radio
de mercado secundario.
Para agregar una cámara secundaria a la pantalla original:
Conecte el conector RCA
hembra
amarillo a la cámara de mercado secundario.
El AXCSD-6V 12 voltios al convertidor de 6 voltios no se utilizará en esta solicitud.
Aísla y omite los siguientes dos cables, no se usarán en esta aplicación: Negro, Amarillo
IMPORTANTE
Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte
técnico al 386-257-1187. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese
de que la instalación se haya realizado exactamente como se indica en las instrucciones. Por
favor tenga el vehículo desarmado y listo para ejecutar los pasos de resolución de problemas
antes de llamar.
Conexiones que se deben hacer
El AXBUCH-MZ6V puede conectarse de dos maneras distintas
Para retener la cámara de reversa de fábrica para un radio de mercado secundario:
Conecte el cable Negro a la tierra del chasis, y también para el cable Negro del AXCSD-6V.
Conecte el cable Amarillo al cable Azul/Rojo del AXCSD-6V.
Conecte el cable de marcha atrás del radio de mercado secundario, a la señal
de marcha atrás en el vehicle, y también para el cable Azul/Blanco de la AXCSD-6V.
Conecte el conector RCA
macho
Amarillo RCA en la entrada de la cámara de reversa del radio
de mercado secundario.
Para agregar una cámara secundaria a la pantalla original:
Conecta el conector RCA amarillo hembra a la cámara del mercado secundario.
El convertidor de 12 V a 6 V AXCSD-6V no se usará en esta aplicación.
Aísla y omite los siguientes dos cables, no se usarán en esta aplicación: Negro, Amarillo
IMPORTANTE
Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte
técnico al 386-257-1187. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese
de que la instalación se haya realizado exactamente como se indica en las instrucciones. Por
favor tenga el vehículo desarmado y listo para ejecutar los pasos de resolución de problemas
antes de llamar.
Metra recomienda técnicos
certificados por MECP
Metra recommends MECP
certified technicians
Metra recomienda técnicos
certificados por MECP

Bekijk gratis de handleiding van Axxess AXBUCH-MZ6V, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkAxxess
ModelAXBUCH-MZ6V
CategorieNiet gecategoriseerd
TaalNederlands
Grootte337 MB