Axxess AXAC-FD1 handleiding
Handleiding
Je bekijkt pagina 5 van 8
5
REV. 9/12/25 INSTAXAC-FD1
CONFIGURATION (CONT.)
Configuration for models without a factory camera:
• Configure the AXAC-FD1 in the Axxess Updater first. In the Axxess Updater
there will be an option box labeled “OEM Programming” under the
“Configuration” tab after the vehicle type has been entered. Check this
box to allow the AXAC-FD1 to configure the camera settings for the vehicle.
(Figure A)
• Turn the key (or push-to-start button) to the ignition position and wait
until the L.E.D. inside the AX-ADDCAM interface comes on. The radio will
reboot and may show a diagnostic screen during this process.
Note: If the L.E.D. in the interface doesn’t come on within a few seconds,
yet blinks instead, turn the key to the off position, disconnect the interface,
check all connections, reconnect the interface, and then try again.
Note: Ensure that the Video 1 input in the interface is set to “reverse
camera”.
(Figure A)
Bekijk gratis de handleiding van Axxess AXAC-FD1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXAC-FD1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1290 MB |
