Axxess AX-TYAMP2-SWC handleiding

8 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 2 van 8
2
CONNECTIONS TO BE MADE
From the 16-pin harness with stripped leads to the aftermarket radio:
Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
Connect the Gray wire to the right front positive speaker output.
Connect the Gray/Black wire to the right front negative speaker output.
Connect the White wire to the left front positive speaker output.
Connect the White/Black wire to the left front negative speaker output.
Connect the Green wire to the left rear positive speaker output.
Connect the Green/Black wire to the left rear negative speaker output.
Connect the Purple wire to the right rear positive speaker output.
Connect the Purple/Black wire to the right rear negative speaker output.
Tape off and disregard the following (6) wires, they will not be used in this application:
Blue/Pink, Brown, Green/Purple, Light Green, Orange/White, Red.
From the AX-TYAMP2-SWC harness to the aftermarket radio:
Connect the Black wire to the ground wire.
Connect the Yellow wire to the battery wire.
Connect the Red wire to the accessory wire.
Connect the Blue wire to the power antenna wire.
If the aftermarket radio has an illumination wire, connect the Orange wire to it.
The following (1) wire is for an aftermarket multimedia/navigation radio that requires this wire.
If not required, tape it off and disregard it.
Connect the Green/Purple wire to the reverse wire.
If retaining the factory AUX-IN jack, connect the Red & White RCA jacks to the AUX input.
Continue to 3.5mm jack steering wheel control retention

Bekijk gratis de handleiding van Axxess AX-TYAMP2-SWC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkAxxess
ModelAX-TYAMP2-SWC
CategorieNiet gecategoriseerd
TaalNederlands
Grootte891 MB