AVM PC 3.3 handleiding
Handleiding
Je bekijkt pagina 9 van 15
Operating instructions
EVOLUTION PC 3.3/ 5.3
9
2.2.2.
Sequential switching on and off
As already explained in chapter 1.4, the sockets are divided into 3 groups:
• 1 group of sockets for sources such as preamplifiers, CD players and other low-power
devices. This entire group is protected by a 2A fuse (accessible at the rear).
• 1 "AMP1" socket (PC5.3 has two "GROUP1" sockets) for power amplifiers/active
loudspeakers on the right channel, which have a higher current consumption.
• 1 "AMP2" socket (PC5.3 has two "GROUP2" sockets) for power amplifiers/active
loudspeakers on the left channel, which have a higher current consumption.
When the device is switched on (and off), these groups are activated (or deactivated) one after the
other with an interval of 1 second. This is to ensure that the mains fuse is not overloaded by too
many electrical consumers being switched on at the same time.
Switch-on sequence:
1. SOURCE-OUTLET
2. AMP2
3. AMP1
2.2.3.
Switching off the device
To switch off the power conditioner, you can use the "POWER" button (2) or the RC 3/ RC 5 remote
control. All socket outlets are then disconnected from the mains. Switching off also takes place
sequentially as explained in chapter
Fehler! Verweisquelle konnte nicht gefunden werden.
.
Switching off via the infrared remote control is generally delayed in order to give other AVM devices
enough time to switch off properly (for more information, see chapter
Fehler! Verweisquelle konnte
nicht gefunden werden.
).
Bekijk gratis de handleiding van AVM PC 3.3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | AVM |
| Model | PC 3.3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2104 MB |
