Audibax M88 DSP Dante handleiding
Handleiding
Je bekijkt pagina 18 van 106
- Starting Time & Release Time: In order to maintain natural oscillation, it is generally
hoped that part of the most original level will pass through the compression without any
influence (or just minor influence). Likewise, if there is a rapid sharp attenuation and rapid
recovery in the signal gain, the suction effect will occur. The starting and release time of
the compressor is to avoid such circumstance. The starting time can decide the speed of
gain attenuation, while the release time decides the speed of gain recovery.
- Output Gain: It is also called gain compensation fader. If the compressor significantly
reduces the level of the signal, it may need to enhance the output gain to maintain the
volume. Such enhancement applies to all parts of the signal and is unrelated to other
parameter settings of the compressor.
G.R. and output Level Meter: G.R. indicates the compressor's compression amount; output
refers to the output level of the signal that has passed through the compressor module.
The compression amount is displayed in an inverse level meter. If the input signal and
threshold are set as -6dB and -30dB, respectively, and the ratio is 2:1, then the
compression amount is 12dB; G.R. level meter indicates around -12dB and output
indicates around -18dB.
Limiter
The limiter only has one key task: make sure that the signal will not exceed the threshold
level in any case. By adjusting the compressor's control parameters, its working modes
will be very similar to those of the limiter. The core working principle of a limiter is that it
really focuses on the signal below the threshold level as well as how the gain attenuation
is produced before the occurrence of overshoot signal. The limit period consists of two
processing stages: during the first stage, there is a minor limit, but the overshoot signal
will not be processed; during the second stage, if there is overshoot signal, it will
attenuate in a very fierce way.
The limiter only provides two parameters: Threshold and Release Time. In terms of signal
processing, occasional clipping will be solved via limiter, while the signal level shall be
attenuated in terms of frequent clipping.
M88 DSP / M88 DSP Dante
www.audibax.com 16
Bekijk gratis de handleiding van Audibax M88 DSP Dante, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Audibax |
| Model | M88 DSP Dante |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13294 MB |
