Atlona AT-UHD-HDVS-300-KIT handleiding
Handleiding
Je bekijkt pagina 15 van 50
AT-UHD-HDVS-300-KIT
15
Use the IPStatic and IPDHCP commands to switch between DHCP and static IP mode using Telnet. Refer to the
Application Programmers Interface documentation for more information. All commands and their arguments are
case-sensitive.
Using Commands
• Setting static IP mode
1. Connect to the AT-UHD-HDVS-300-TX using Telnet.
2. At the command line, execute the IPDHCP command using the o argument, as shown.
IPDHCP o
3. Execute the IPStatic command. This command requires three arguments: the desired IP address of the
AT-UHD-HDVS-300-TX, the subnet mask, and the gateway address. All arguments must be entered in dot-
decimal notation. The following is an example:
IPStatic 192.168.1.112 255.255.255.0 192.168.1.1
4. Power-cycle the AT-UHD-HDVS-300-TX.
5. The unit is now set to static IP mode and ready for use.
Installation
• Setting DHCP mode
1. Connect to the AT-UHD-HDVS-300-TX using Telnet.
2. At the command line, execute the IPDHCP command using the on argument, as shown. All characters are
case-sensitive.
IPDHCP on
3. Power-cycle the AT-UHD-HDVS-300-TX.
4. The unit is now set to DHCP mode and will be assigned an IP address by the DHCP server (if present).
Bekijk gratis de handleiding van Atlona AT-UHD-HDVS-300-KIT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-UHD-HDVS-300-KIT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6185 MB |
