Atlona AT-UHD-CAT-4 handleiding
Handleiding
Je bekijkt pagina 11 van 45
AT-UHD-CAT-4
11
Installation
3. Execute the IPStatic command. This command requires three arguments: the desired IP address of the
AT-UHD-CAT-4, the subnet mask, and the gateway address. All arguments must be entered in dot-decimal
notation. The following is an example:
IPStatic 192.168.1.112 255.255.255.0 192.168.1.1
• Setting DHCP mode
1. Connect to the AT-UHD-CAT-4 using RS-232 or Telnet.
2. At the command line, execute the IPDHCP command using the on argument, as shown. All characters are
case-sensitive.
IPDHCP on
Once DHCP is enabled, the unit will be assigned an IP address by the DHCP server (if present).
The System page (page 35), in the web server, allows the AT-UHD-CAT-4 to use either DHCP or static IP mode.
In order to access the web server, the IP address of the AT-UHD-CAT-4 must be known. Refer to Introduction to the
Web Server (page 29).
1. Open the desired web browser and enter the IP address of the AT-UHD-CAT-4.
2. Log in using the required credentials. The factory-default username and password are listed below:
Username: root
Password: Atlona
3. Click System in the menu bar.
4. Click the IP Mode toggle to switch between the DHCP and STATIC IP setting. When set to STATIC IP, the
IP, Netmask, and Gateway elds can be modied.
Setting the IP Address using the Web Server
5. Click the Save button to save the changes.
IP address Subnet mask Gateway
Bekijk gratis de handleiding van Atlona AT-UHD-CAT-4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-UHD-CAT-4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6046 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Gewicht | 1660 g |
| Breedte | 222.25 mm |
| Diepte | 261 mm |
| Hoogte | 44 mm |
