Atlona AT-OMNI-122 handleiding
Handleiding
Je bekijkt pagina 38 van 129
AT-OMNI-121 / AT-OMNI-122
38
Basic Conguration Tutorial
• Verify that all encoders and decoders are set to the same system mode. In this tutorial, both encoders and the
decoder should be set to VCx. Refer to Setting the System Mode (page 27).
• Go to the Input menu and make sure that the Cable present indicator, under the Input 1 window group,
is green. If it is not green, replace the HDMI cable or the encoder EDID. Refer to Conguring Inputs (page 28)
for more information.
• Go to the Encoding menu and verify the following under the Encoder 1 window group. Refer to Encoder
Settings (page 30) for more information.
» Make sure the Input drop-down list is assigned to an input. In this tutorial, the Input eld, under the
Encoder 1 window group, is set to hdmi_input1.
» Verify that the Max bit rate eld is set to at least 450.
» Verify that a Thumbnail > Enable toggle switch is enabled and a thumbnail of the source is displayed.
• Go to the Session menu and verify the following under the Session window groups. Refer to Creating a Session
(page 31) for more information.
» Make sure the Interface eld for both encoders is set to eth1.
» Check that the Scrambling > Enable toggle switch is enabled. Also check that the Scrambling > Key eld,
for this example, is set to scrambling.
» Verify that the Video > Enable toggle switch is set to enabled.
» Check the Video > Destination IP address eld is set to the correct multicast IP address. In the example,
226.0.0.1. is used on Encoder #1 and 226.0.0.2 is used on Encoder #2.
» Check that the Video > Destination UDP port eld is set to 1000.
» Make sure the Audio > Source is set to hdmi_input1.
» Verify that the Audio > Enable toggle switch is enabled.
» Check the Audio > Destination IP address eld is set to the correct multicast IP address. In this example,
226.0.10.1 is used on Encoder #1 and 226.0.10.2 is used on Encoder #2.
» Check that the Audio > Destination UDP port eld is set to 1100.
If no video and/or audio is present on the display, check the following for both Encoder #1 and Encoder #2,
unless otherwise noted.
Encoder Checklist
Troubleshooting
Bekijk gratis de handleiding van Atlona AT-OMNI-122, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-OMNI-122 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 18571 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Gewicht | 700 g |
| Breedte | 208 mm |
| Diepte | 112 mm |
| Hoogte | 34 mm |
