Atlona AT-OMNI-122 handleiding
Handleiding
Je bekijkt pagina 31 van 129
AT-OMNI-121 / AT-OMNI-122
31
Basic Conguration Tutorial
Creating a Session
Before the video and audio (if any) can be sent out over the network, a session must be created on the encoder.
The session assigns each stream to a unique multicast IP address and UDP port assignment. Sessions are always
created on encoders. The following procedure should be performed on both AT-OMNI-111 encoders, except where
noted.
1. Click Session in the menu bar.
2. Under Session 1, the Name eld indicates the session name. This value is set to session1 and cannot be
changed.
3. The Interface drop-down list assigns the
session to an Ethernet output. This can be
changed to eth1 or none. For this example,
Session 1 will be transmitted over the
ETHERNET 1 port. Therefore, set this to eth1.
4. The Scrambling > Enable toggle switch is
enabled by default. When enabled, this toggle
will be orange. Leave this setting enabled.
1
2
3
4
5
6
7
8
5. The Scrambling > Key eld is set to scrambling by default. Scrambling keys can be any combination of
alphanumeric characters and it is good practice to use them. For this tutorial, use the default key.
6. Select the encoder for the session. In this example, hdmi_input1 is assigned to Encoder 1 (refer to Step 2 on
previous page). Therefore, set the Video > Encoder eld to encoder1 for Session 1.
7. Click the Video > Enable toggle switch and make sure it is enabled for Session 1. When enabled, the toggle
switch will be orange. If set to disabled, then the encoder video stream will be disabled.
8. Enter the multicast IP address for the video stream in the Destination IP address eld. Atlona recommends
using multicast IP addresses as shown in Table 2.1, on the next page. Enter 226.0.0.1 in the Destination IP
address eld for Session 1 on Encoder #1. For Encoder #2, enter 226.0.0.2 in the Destination IP address
eld for Session 1.
Bekijk gratis de handleiding van Atlona AT-OMNI-122, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-OMNI-122 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 18571 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Gewicht | 700 g |
| Breedte | 208 mm |
| Diepte | 112 mm |
| Hoogte | 34 mm |
