Atlona AT-OMNI-122 handleiding

129 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 20 van 129
AT-OMNI-121 / AT-OMNI-122
20
Connection Instructions
1. Connect an Ethernet cable from the ETHERNET port on the decoder to a PoE-capable switch on the Local Area
Network (LAN). If using the dual-channel decoder, connect a separate Ethernet cables to ETHERNET 1 and
ETHERNET 2 ports.
5. IR (optional)
IR emitter
Connect the IR emitter to the TX and GND pins of the RS-232 2 port. The IR emitter must be placed no
more than one inch from the IR sensor on the device, in order to function properly.
IR extender
Connect the IR extender from the RX and GND pins of the RS-232 2 port to the associated pins on the
control system.
6. Once power is applied, the PWR indicator, on the front panel, will turn red, then amber, then green.
Installation
IMPORTANT: If a PoE-capable switch is not available, then the 48V DC power supply (sold
separately) must be connected to the decoder.
IMPORTANT: When using analog audio inputs on the OmniStream decoder, the decoder must
be powered using the 48V power supply (AT-PS-48083-C). This power supply is sold separately
and can be purchased from Atlona.
2. Connect an HDMI cable from the HDMI OUT port on the decoder to a display. If using the dual-channel
decoder, connect an HDMI cable from each HDMI OUT port to a display.
3. RS-232 (optional)
Connect the RS-232 device to the RS-232 port on the decoder.
4. External Audio (optional)
Connect the audio inputs to the decoder, as required.
Connect the audio outputs to the decoder, as required.

Bekijk gratis de handleiding van Atlona AT-OMNI-122, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkAtlona
ModelAT-OMNI-122
CategorieNiet gecategoriseerd
TaalNederlands
Grootte18571 MB

Caratteristiche Prodotto

Kleur van het productZwart
Gewicht700 g
Breedte208 mm
Diepte112 mm
Hoogte34 mm