Atlona AT-HDR-H2H-44M handleiding
Handleiding
Je bekijkt pagina 10 van 21
AT-HDR-H2H-44M
10
Installation
Control
A 5-pin captive screw connector for control has been included. The rst three terminals are RS-232 control, the last
two terminals are for IR.
1. Use wire strippers to remove a portion of the cable jacket.
2. Remove at least 3/16” (5 mm) from the insulation of each wire.
3. Insert the wires into the correct terminal on the included captive screw connector, as shown below.
4. Tighten the screws to secure the wires. Do not use high-torque devices as this may damage the screws and/or
connector.
Pin out will be determined by the
RS-232 cable and connect as
RX (receive), TX (transmit) and
(Ground).
IR IN is connected by a ground and signal wire.
Use with 3rd party control systems. For easy
termination, Atlona recommends using the 2
meter IR cable AT-LC-CS-IR-2M.
RS-232 IR
GND
S
GND RX
TX
GNDRX TX
Mounting Instructions
The AT-HDR-H2H-44M can be mounted in a standard 19-inch rack or placed freestanding on top of a desk or table.
Rack installation
1. Remove the front two case screws from the sides of the case.
2. Attach the included rack ears to each side of the AT-HDR-H2H-44M using the case screws.
3. Install the HDR-H2H into a rack, using four rack screws.
AT-HDR
AT-HDR-H2H-44M
1 2 3
4
RS-232 IR IN
HDMI IN LAN FW DC 24V
SRX TX
OUTPUT 1
OUTPUT 2
OUTPUT 3
OUTPUT 4
AT-HDR-H2H-44M
1
2
3
4
POWER
FNC EDID INFO
ENTER
CANCEL
Bekijk gratis de handleiding van Atlona AT-HDR-H2H-44M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Atlona |
| Model | AT-HDR-H2H-44M |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2261 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Gewicht | 4000 g |
| Breedte | 438 mm |
| Diepte | 254 mm |
| Hoogte | 44 mm |
