ATen VK211 handleiding
Handleiding
Je bekijkt pagina 15 van 35
7
Chapter 3
Configuration
Overview
This chapter provides recommended procedure and required information on
setting up
Remote Control through Contact In
With the contact in port wired and connected to the controller (page 5), you can
store up to 4 sequences of keystrokes (presets) and trigger the sequences
from a keypad or a software control interface. To configure and store these
sequences, use the priority button on the VK211 panel or remotely with CLI
commands.
Configuring Presets with Learning Mode
To set up a preset with the priority button:
1. Select a preset.
a) Press and hold the priority button for about 3 seconds until preset 1
LED blinks to enable learning mode.
b) To configure preset 1, continue to the next step; to select another preset,
press the priority button to cycle through the presets. A preset LED
blinks to indicate that it is selected.
2. Perform the control action(s) on the local keyboard.
Note: The converter exits learning mode if no input is received within 5
seconds.
3. Press the priority button to finish learning. The preset LED dims.
Configuring Presets through CLI Commands
To set up a preset remotely with CLI commands, refer to the next section on
how to create an RS-232 session (page 8) and the command syntax for
configuring contact in ports (page 10).
Bekijk gratis de handleiding van ATen VK211, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ATen |
| Model | VK211 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2281 MB |
