ATen CM1942 handleiding
Handleiding
Je bekijkt pagina 21 van 60
9
Chapter 2
Hardware Setup
Cable Connections
To set up your installation, refer to the installation diagram on the following
page (the numbers in the diagram on page 10 correspond to the steps below),
and do the following:
1. Connect your USB keyboard and USB mouse to the unit’s USB 2.0 Type-
A ports.
2. Connect up to two HDMI-enabled displays to the unit’s HDMI output
ports.
3. Connect your primary microphone and speakers to the unit’s audio jacks
located on the front panel. Optionally, connect your secondary microphone
and speakers to the unit’s audio jacks located on the rear panel.
Note: The microphone and speakers connected into the front panel have
priority over those connected into these jacks.
1. Important safety information regarding the placement of this
device is provided on page 41. Please review it before
proceeding.
2. To prevent damage to your installation from power surges or
static electricity. It is important that all connected devices are
properly grounded.
3. Make sure that power to all the devices you will be installing has
been turned off. You must unplug the power cords of any
computers that have the Keyboard Power On function.
4. Please operate the device with caution when under high
environmental temperatures, as the surface of the device may
become overheated under such conditions. For instance, the
surface temperature of the device may reach 70 °C (158 °F) or
higher when the environmental temperature reaches close 50 °C
(122 °F).
Bekijk gratis de handleiding van ATen CM1942, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ATen |
| Model | CM1942 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4151 MB |
