Handleiding
Je bekijkt pagina 36 van 52
SolutionPossible causeSymptom
After the hob has cooled down,
cooking can be continued.
Zone is overheated.Zone stops unintended and
residual heat indicator is shown.
Check the electrical
connections.
The appliance is incorrectly
connected.
A fuse blows when the hob is
connected to the electrical
power mains.
Disconnect the device from the
power supply. Contact your
installer.
The ceramic glass plate broke.
Please note! Do not throw a
broken ceramic glass plate in
the glass recycling bin but take
this to the Municipality's waste
recycling centre.
Error codes
SolutionPossible causeSymptom
Disconnect the device from the mains,
wait 10 seconds and reconnect.
Defective generator.Error codes F0 to F7 and FC.
Contact the technician if the error code
does not disappear.
Let the appliance cool down and start
cooking again.
Appliance overheated.Error codes Fc
Have your connection changed.The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Error code FC02
Disconnect the device from the mains,
wait 10 seconds and reconnect.
Control panel errorError codes Fc01, FC04,
FC08 , FC10 and FH
Contact the technician if the error code
does not disappear.
Contact your energy supplier.Mains voltage is too low.Error codes FJ
Make sure the venting holes under the
cooking plate are open.
Air circulation not good.Error codes F9
Contact the service department.Other error codes.
NOTE!
In case of other error codes: please write down the error code and contact the service department.
Table continued from last page
36
Troubleshooting
Bekijk gratis de handleiding van Asko HI5643FMG1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Asko |
| Model | HI5643FMG1 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3531 MB |
