Arturia Mix DRUMS handleiding
Handleiding
Je bekijkt pagina 38 van 58
Frequencies below the Crossover are sent to the LOW module, where a "dry" signal is run in
parallel with a saturated one.
5.2.1. OP AMP 21
The OP AMP 21 module is a model of an operational amplifier gain stage, which provides
warm saturation and gain boost. It's been taken from the DIST OPAMP 21 distortion effect in
Arturia's FX Collection, and has the following controls:
• Warmth: The amount of distortion. Settings range from 0% to 100%.
• Level: The amount of makeup gain applied after the distortion stage. Settings
range from Off to 24.0 dB, default is 0.00 dB (unity gain).
• Dry: The amount of Dry signal passed through along with the saturated signal.
Settings range from Off to 24.0 dB, default is 0.00 dB (unity gain).
Note that the Dry signal here is not
completely
dry. It's routed through a preset tape clipper of its
own, which imparts character without oversaturating the signal when hit with a loud signal.
5.2.2. Low Shaper and Clipper
Once the two signals have been recombined, they are sent through the Low Shaper. This
is a
transient shaper
, a processor that lets you control the transients of drum hits. You can
make the attacks of drums very short or de-emphasize them, and you have similar control
over the sustained sound that follows the attack.
The Shaper controls are:
• Attack Gain: Sets the amount of gain boost or cut given to the attack of each
drum hit. Settings cover ±10.0 dB. The red line on the Attack graphic gives a visual
representation of how the attack is being altered.
• Attack Time: This slider sets how long the Attack shaping lasts. Setting ranges
from 5 ms to 200 ms.
• Body Gain: Sets the amount of gain boost or cut given to the body of each drum
hit (the sound after the attack). Settings cover ±10.0 dB. The red line on the Body
graphic gives a visual representation of how the body is being emphasized or
damped down.
• Body Time: This slider sets how much time it takes to reach the chosen dB value.
Setting ranges from 5 ms to 200 ms.
The last stage of processing in this module is a final tape clipper, and the Clipper meter
shows where the level of the signal is sitting as it exits the Low module. You can adjust the
Level and Dry controls for the sound you like, while maintaining optimal levels.
33 Arturia - User Manual Mix DRUMS - The Audio Path
Bekijk gratis de handleiding van Arturia Mix DRUMS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Arturia |
| Model | Mix DRUMS |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6795 MB |
