Arturia MiniBrute SE handleiding
Handleiding
Je bekijkt pagina 33 van 51
Arturia MiniBrute SE User's Manual 33
4.2.2.1 Mode
This selects among the four filter modes: LP (low-pass), BP (band-pass),
HP (high-pass), and Notch. The LP mode is the most commonly-used,
and provides sounds which are full/fat and round. The BP and HP modes
provide thinner and harsher sounds. When modulated by the LFO, the
Notch filter mode sounds similar to a phaser effect pedal.
4.2.2.2 Cutoff
This knob adjusts the filter’s cutoff frequency. The frequency range goes
from below 20Hz when turned fully counter-clockwise up to 18kHz when
fully clockwise. For example, in LP mode you can adjust a sound’s
brightness. As an exercise, set all the oscillator mixer slider
potentiometers to 0 (lowest position). Adjust the NOISE generator slider
to midrange, then set all the filter envelope [4.2.2.7] and amplifier envelope
[4.2.3.1] sliders to 0. Move the amplifier envelope SUSTAIN slider to its highest
position. Set the filter mode to LP, turn the ENV Amt knob [4.2.2.4] to 12 o'clock and
set KBD Tracking knob [4.2.2.5] on Off, then press a key and tweak the Cutoff knob
as you listen to the changes in the sound.
The cutoff frequency can also be controlled by the keyboard [4.2.2.5] as well as by the rear
panel Filter CV input [4.3.6].
4.2.2.3 Resonance
This knob lets you create a resonance peak at the cutoff frequency.
Turning it clockwise emphasizes the partials at the cut-off frequency,
and the sound becomes more aggressive. When the knob reaches its
last quarter zone, the filter starts to oscillate on its own. However this
oscillating behavior depends on the cutoff frequency; the MiniBrute
filter oscillates within a range beginning around 350Hz up to approximately 8kHz. To
extend the oscillation range, use the Brute Factor knob [4.2.8.4].
4.2.2.4 ENV Amt (envelope amount)
The ENV Amt lets you control the amplitude and polarity of the envelope signal
sent to modulate the filter cutoff frequency. At the 0 position (12 o'clock), no
envelope modulation occurs. When turned counter-clockwise (below the 0 mark),
the ENV Amt knob sends an increasing amount of the inverted ADSR envelope.
When turned clockwise (beyond the 0 mark) the ENV Amt knob sends an
increasing amount of the standard, positive-going ADSR envelope.
Bekijk gratis de handleiding van Arturia MiniBrute SE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Arturia |
| Model | MiniBrute SE |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11481 MB |
