ART Multiverb Alpha 2.0 handleiding
Handleiding
Je bekijkt pagina 23 van 61
19
Transferring all presets to another MULTIVERB ALPHA 2.0 or a suitable MIDI
device is accomplished by selecting the SEND ALL PRESETS value and pressing the
Enter button.
IMPORTANT NOTE For:
RECEIVING Preset and MPT Information
To dump MIDI data into the MULTIVERB ALPHA 2.0 from either another MULTIVERB
ALPHA 2.0 or an external MIDI device you must make sure that the MIDI channels
match or OMNI mode is used. The MULTIVERB ALPHA 2.0 will accept MIDI data at all
times regardless of what operating mode it is in.
PERFORMANCE MIDI [PM]
Performance Midi allows the MULTIVERB ALPHA 2.0 to have up to eight of its
parameters per preset controlled simultaneously via MIDI. Selection of the
parameter to be controlled, the actual MIDI controller, the Scale of the
adjustment ratio and the starting Center Point of the Scale may be programmed
from the front panel.
When you are in Preset or Edit Mode, the LCD will inform you of either
Performance MIDI or FX ON/OFF information being received and what is being
changed.
There is also a means to monitor MIDI information being sent to the MULTIVERB
ALPHA 2.0. While you are in the PM Mode you can select the MIDI Monitor utility
and verify MIDI data being sent to the device. Refer to the MIDI DataMONITOR
section for additional information.
A table of MIDI controllers can be found in Appendix E, Tables and Charts.
Presets in the ALPHA 2.0 are set up to be controlled by Performance MIDI via the
ART X-15 ULTRAFOOT. See the section Operating the Multiverb ALPHA 2.0 with the X-
15 ULTRAFOOT further on in this manual for more information. Don't let MIDI scare
you, using Performance MIDI in an ART device is easy. In most cases (especially
with an X-15) you virtually plug in and play. But, if you want to program, we've
made that easy too.
Modification to select the specific values and ranges you want the parameter to
cover is done by normal editing. The number displayed in the upper left corner
represents the MIDI Controller you are working with.
Performance MIDI has four levels of programming information associated with it
broken up into 4 screens. The first screen displays the information to define
what parameter the assigned MIDI controller will control.
The second screen shows which MIDI controller is being used. The LCD will display
the MIDI control number and its description (i.e. MC 4 FOOT CTLR). Incidentally,
the default value is MC 4 which happens to be the Left Foot Controller on the X-
15. The MIDI DataMONITOR may be selected for use in this screen to display MIDI
data being sent.
The third screen displays the LOW value (minimum value) of the parameter's range.
The fourth screen displays the HIGH value (maximum value) of the parameter's
range. High and Low values refer to MIDI controller values. These parameters may
be "swapped" to make the value change in a reverse or opposite direction.
Bekijk gratis de handleiding van ART Multiverb Alpha 2.0, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ART |
| Model | Multiverb Alpha 2.0 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3879 MB |
