ART Multiverb Alpha 2.0 handleiding
Handleiding
Je bekijkt pagina 19 van 61
15
Remote 1 or Remote 2 can be assigned as the Trigger and Remote 2 may be assigned
as the Re-Arm.
These jacks may also be programmed to increment and decrement through a set of
presets. Remote 1 may be set for incrementing up and Remote 2 may be set for
decrementing down. For decrement program to work, you must program Remote 1 for
increment. You can not program the Remote 2 jack for decrement alone.
AUTO PM DISPLAY [ALWAYS DISPLAYED]
OFF, PRESET ONLY, ALWAYS DISPLAYED
This utility let's you set when the LCD displays Performance MIDI messages. When
set to OFF, no message is displayed when the ALPHA 2.0 receives Performance MIDI
messages. Preset Only allows messages to be displayed when in Preset Mode or when
editing a preset. Always Displayed means the MIDI message will be displayed
whenever the ALPHA 2.0 receives a (Performance) MIDI message.
NOTE: The ALPHA 2.0 always receives MIDI messages and responds to them. Only the
display is affected when setting this value.
LCD View Angle [6]
Allows the viewing angle of the LCD Display to be adjusted. You may change the
LCD view angle for the best visibility. The angle may be adjusted to maximize
readability of the characters from top, front or under viewing angles. When
viewing from the top, use a higher number. If you are viewing the display
directly from the front, use the middle numbers. Viewing the LCD when the ALPHA
2.0 is above you, adjust the view angle to the lower numbers.
Software Version Level
Displays the software revision level currently installed in the MULTIVERB ALPHA
2.0. The current version as well as the date will be displayed in the LCD. The
MULTIVERB ALPHA 2.0's software is contained in a socketed EPROM and is field
replaceable. This software controls the MULTIVERB ALPHA 2.0's functions as well
as its sounds. For your convenience write the software version in the space
provided on the Introduction page at the beginning of the manual.
Preset Memory Allocation
MEMORY USED= ##
AVAILABLE= ####
Displays how much user memory has been used and how much user memory is available
for further storage.
This utility informs you how much User Preset Memory has been used or how much
memory there is available for storing presets. When you first access user memory
there are approximately 5500 bytes (5.5 Kbytes) of space available. Each time you
store a preset more space is used up. If the display will inform you that there
is space available, but you are not allowed to store any more information, don't
worry. You have probably stored, deleted, edited or moved presets and information
thousands of times. The memory must be purged and reallocated. Save your presets
to a MIDI storage device and perform a factory reset then reload your presets.
Previous unavailable memory space is now free for storing information.
Recall Factory Preset
Bekijk gratis de handleiding van ART Multiverb Alpha 2.0, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ART |
| Model | Multiverb Alpha 2.0 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3879 MB |
