Arktic 274224 handleiding
Handleiding
Je bekijkt pagina 14 van 160
14
GB
WARNINGS!
1. Never switch on the machine if the bowl lid is missing. Before
removing the bowl lid, switch off the machine and unplug it.
2. There are some moving parts inside the bowl, which
may cause injuries, switch off the machine and un-
plug it before carrying out any operation.
c) Start operating the machine:
(Control panel : Fig.2 on page 3)
Each bowl is controlled independently.
• First, connect the power plug to a suitable electrical power
outlet.
• Next, press
(21)
to switch ON the machine. Press and hold
(21)
for 3 seconds to switch to STANDBY mode of the machine
when not use.
(Fig.8 on page 5).
• Then, press the corresponding bowl button
(12)
.
And press consecutively to select the working mode.
There
are 3 working modes: Granita (18) , juice (19) or OFF (20). It
will be displayed in sequence and the corresponding icon will
be lighted.
I). To serve with Granita
(Fig.9 on page 5)
• Press the corresponding bowl button
(12)
.
• Next, press consecutively to select Granita mode,
(18)
will be
lighted.
• Then, press “+” or “-” consecutively to adjust the hardness.
The level in between from 1 (Soft with much water content) to
7 (Hard with less water content).
II). To serve with cold drinks
(Fig.10 on page 5)
• Press the corresponding bowl button
(12)
until
(19)
lights up.
• Enter to juice temperature setting mode by long pressing
(22)
until “PR” is blinking on the display.
• Press
(22)
again to select bowl 1(F1) or 2(F2) until “F1” or “F2”
is shown on the temperature display.
• Press
left panel (17)
to adjust the temperature from 1°C ~ 7°C.
The temperature will be set successfully. After flashing 15
times without any operation, the display will return to normal.
NOTICE:
• Current temperature is showing on display as normal.
• Press
(14)
and
(16)
at the same time for restoring to default
temperature( 2°C ).
• Display shows “PR” / “F1” / “F2” : Juice temperature setting
mode / bowl 1 / bowl 2. The mode will become invalid after
flashing 15 times without any operation and display will switch
back to normal.
• Only
left panel (17)
can be operated (for both bowl 1 and 2)
within juice temperature setting model.
III). To stop working
• Press the corresponding bowl button (12).
• Next, press consecutively until OFF mode, (20) will be lighted.
Then, it would stop stirring and refrigerating.
d) To simply clean the corresponding bowl:
• Press and hold the corresponding bowl button
(12)
for about
6 seconds.
• The corresponding bowl valve will be fully open for cleaning
about 3 minutes. During this mode, the control display will
show “°C”.
ATTENTION!
Under this mode, the electronic expansion valve of
the corresponding bowl will open. But the auger still stirring for
cleaning. Please fill with warm and clean water into the bowl
not exceeding the “MAXIMUM LEVEL”. Do not put your hand in-
side.
Switch OFF the machine and unplug it for thorough cleaning or
sanitization to the machine.
e) Dispensing granita
(Fig.11 on page 6)
• To dispense the food product, pull the tap lever.
NOTE
: Regularly check the temperature of the beverages in the
bowl (2). Keep on the machine running when there is any
food inside the bowl.
If the machine is not continuously operated, it is necessary to
dispose of the small amount from the tap area first before serv-
ing for the customer.
Parameter Setting of the Machine
WARNING! It is highly not recommended to change
these settings below as the machine is already adjusted to the
optimal settings by the factory default. Change the setting only
if it is necessary.
How to set
Press and hold (22) for about 6 seconds. The “PA” is shown on
the display.
Press “+“ or “-“ to enter the value “15“ (This is the code for
entering into the setting mode).
Then, press (22) consectively to select the parameter (display
will show consectively) that you want to change. The parame-
ters are list below:
Display Description
Setting
range
Factory
default
F1
Temperature of Bowl I under
juice mode
1°C ~ 7°C 2°C
F2
Temperature of Bowl II under
juice mode
1°C ~ 7°C 2°C
F3 Not applicable
C1
Protection when the temperature
is low
-13°C ~ -3°C -5°C
C3
Liquid temperature during first
stage
5°C ~ 10°C 10°C
C4
Liquid temperature during
second stage
3°C ~ 8°C 5°C
A1
Sensor probe temperature for
bowl I
-5°C ~ 5°C 0°C
A2
Sensor probe temperature for
bowl II
-5°C ~ 5°C 0°C
A3 Not applicable
E1
Temperature difference under
juice mode
1°C ~ 5°C 2°C
E2 Time delay of compressor 2 ~ 8 min 2 min
Bekijk gratis de handleiding van Arktic 274224, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Arktic |
| Model | 274224 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 24497 MB |
